Here are some News from a greek user that commented on my last video:
Sotiris Papadelos1 day ago
1) he was hiding with white tape the electronic board with the 3 phase radio wave emitters
2 ) his invention is using a material that act as a torch, Ag in this case, so he can break Apart the molecule at low frequencies.
No need to reach the 6-7 pico hertz, the natural hydrolysis frequency that needs huge amount of energy.
overunitydotcom1 day ago+Sotiris Papadelos
So you say the metal plate is just a silver plate ? I have read in one article that he is using colloidal silver somewhere in his new reactor...
Hmm, can you confirm that in this in vitro glas test tube he used a silver plate as the virtual electrode ? Looked more like a brass metal plate... hmm...
Sotirios Papadel1 day ago+overunitydotcom colloidal silver is used at water tanks for permanent hydrolysis.
Silver plate is used here to explain and present the phenomenon of amplifying the resonance through this plate, acting as an electromagnetic torch.
It does not work as virtual electrode.
overunitydotcom11 hours ago+Sotirios Papadel
I see, but how does he do it in his new reactor, where he pulls seawater directly from the Greek shoreline and puts it into his reactor..
Where does he have there colloidal silver ? Did he add this before or does the RF frequency mix generate from the silver plate some colloidale silver particles to be released from the metal and are surrounding the silver plate as a colloidal fluid then ?
overunitydotcom11 hours ago+Sotiris Papadelos
Are also the 3 phase radio wave emitters powered by the 7.5 Volts and 50 mA, so only by 350 MilliWatts of input power ? Or were they powered by Li-Ion batteries below the tape somehow ?
Sotiris Papadelos2 hours ago+overunitydotcom
He has placed colloidal silver in a pill form, and place it within the sea water tank. When the colloidal silver is decomposed, the amplifying effect stops, and silver changes to precipitation form. It then needs electrophoresis to come over to its original properties.
Sotiris Papadelos2 hours ago +overunitydotcom
The emitters must always run at 350MilliWatts. He can either have an external source for that or, Through redox with special coating can create this small amount of power, or in later stage video, Mr Zografos has created a polymer membrane that when comes to Hydroxy (HHO) contact, divertes directly the HHO gas to electricity and then powers the emitters and the external loads. That is the 2nd scientific Breakthrough of the invention.
http://www.hellagen.gr/