For now I will be working on the valve power supply and going over SM posts agains.  So the valve can be seen to have DC with AC signal in it?  Hmm similar to TPU output!  Perhaps we have been looking in the wrong place for kicks.  Perhaps an interaction in the earths field can happen with pulsed DC signal and an AC signal in the same wire or something?

Regards,

Dave.

yup Dave

there defanatly will be AC riding on the DC output of this type of pwr supply (and many other types)
just make sure that you don't use the filter cap on the output side & you should see it for yourself

Jason,

Sorry mate.  I realise what you are saying now, applogies.

I guess that you could use a FET between one side of your cap and the primary.  Of course no current will flow if the other end of the primary is not connected to anything.  But whether this will work, you will have to try.  I mean if the original signal was coming from say a 555 timer, its output is only an internal transistor anyway?  So if you use a charged cap and a transistor with open ended primary, surley you have the same thing but larger?!

Also, in the version with 555 timer and open ended primary, its a bit like the HV thing I mentioned.  There may be no current flow as such, but the free electrons can bunch up on one end of the wire and then the other depending on the potential at the 555 output.  So you get longitudinal oscillation of electrons in the wire, but no closed loop current.  These will of course create a magnetic field as they move and this will couple with your secondary like an antenna?!

So, looking from this angle, will charged cap, with mosfet and open primary still work>!

I guess if you have a greater potential switching at one end of the wire, the longitudinal compression in the wire will be stronger the thus stronger magnetic field, but the cap cannot changes its potential?  Unless you have two caps, with two fets.  One cap is the other way around, one fet is P type.  Then you can switch the base of the coil between potentials while leaving the other end open and create this longitudinal movement!



Dave.

Hi Dave,

You got it! And I have good news for you. I KNOW THIS WORKS!! I have already built the transformer circuit and I pulsed it with one wire from my function generator and it will indeed induce oscillations in the secondary! the most power I got out of it was about 0.5W with about 9V RMS input from the function generator, but I noticed that the power increases linearly with the voltage input so Vout = 4 * Vin with my particular setup. Now, the current isn't very high but as I showed in my demo videos, just adding a piece of something metal in the circuit increases the current output!

Could you perhaps send me a diagram showing how to properly connect the MOSFET, the cap and the 555 timer? I want to make sure that the pulse part at least works right as I know from experimentation that the rest will work :-). I heard something about needing to ground the base of the MOSFET to keep it from switching on by itself but since my circuit is not grounded and I don't want to make any kind of complete circuit with the cap, how do I deal with that problem?

God Bless,
Jason O

God Bless,
Jason O

Hi Darren,

I have just performed a simulation.  In the simulation the voltages do not add.

When I compare the phases they are not 100% aligned either.  So the software will not add them?

In any event, as you all say, the voltage cannot do this, its impossible?  So why are we looking for it in simulation software that is designed to follow the rules?

Everyone is telling me it cannot happen but has anyone built a real circuit to prove it is right or wrong?

We are here to challenge our knowledge and push past our conventional training.  I post something that may be odd and I get shot down in flames by people who are supposedly on a free energy forum because they have open minds and want to look for the answer?  Yet no one builds it, they just tell me its crap.  With this attitude, no free energy device will come from this forum?

In any case, I posted this asking for peoples thoughts.  I did not come on here saying I have found free energy.  But you would never believe it from the responses, anyone would think I came claiming I have discovered OU in a circuit that is so simple you will laugh?



Dave.

Dave, you did put the 2 first transformers in parallel.
This way the voltages will not add.
You must put them in series.

But as the impedance will also add, there is no power gain !

Please can you try th circuit I suggested with 2 noise generators into
the 2 x 12 Volts coils out of phase and post the voltage at the 240 Volts coil output ?
Many thanks.

Earlier back many pages. I don't recall anybody else mentioning this.
My famous statement is could be wrong!

With the square wave appeared BEMF.
With the two beat frequencies, SM3 & SM6 uses one then the earth's. The SM17 uses 2 of it's own. The 17" is not cylindrically at the wavelength of the freq inherent with the earth. The other two are. Now with any two freqs against each other there appearsa harmonic.
The idea here was to get the Kick from each BEMF to harmonize at the coil edge. That is 3 of the elements needed. The fourth element is tuning which now the collector/antennaes at the right distance would be of the correct parameters to be in tune with the Freak wave harmonic.
Thus power out. The fifth element is us. Just like the movie. What are the potentials.
I stated this before. Search on Freak wave.
I also posted a wave testing site to allow the simulations of harmonics. Did anybody go there? Has anybody read anything?
I don't want to see anybody waste their time. This work is very relevent. With the potential products and applications that I previously mentioned I see this variable high speed magnetic vortex the next big leap for mankind. The SM devices are just a part.
Could I be wrong?
Thank you for your time. I'll put my head down now...

I have no idea what I would be looking for (even if I was set up to build a pwr supply),
but I think I would know if something is happening that's not SUPPOSED to be happening ,


and if SM could find it, then so could we .

No sir. I have no alternate defination other that what you have said.
Tesla worked this also.

dave,

i think that was what tesla was studying.  the kicks that he was studying were exactly that,  the ones that occured and were killing people when the circuit was turned on.  i think stevens analogy of thinking of a wire several miles long and being able to stop the current before it got to the other end, may be the fly in the ointment. so to speak!  with that in mind do you still think your experiment that showed this kick is still in total error?

lol
sam

ps: i guess you were busy while i was at the nascar race in talledega yesterday.  great experiment with the sign wave and transformers.  looks like very reproducible kicks to me to.  that is if you know how to read a scope.

One more time, Dave!
I can't believe my engineering eyes.?!./!?.1/???
And I believe you showed the current as the same? I forgot. It's been such a long time ago, so many posts...
But the jury is in and verdict is Guilty of doubling the voltage from nothing. All in favor say aye! AYE!

What prestidigitation is next?
And no, I don't have scope shots yet. Am still putting the last wires on. I just don't have the time. Ya know, with this huge stream of posts. Well, I'm just overwhelmed. Not just whelmed. I gotta go see my therapist tomorrow. The meds have worn off and I like what I have been seeing from your tests and others tests.
Congrats. I believe now. Didn't you say you're a medical supply person? Well I am a financial database programmer and hate electronics. But that is where I have a patent. Go figure?
Thanks for the hard effort. Now git yerself a beer and put your feet up. Your results can be added to Marco's coil kick results.
It has been a good day!