In my next project will try to replicate the "The new generator no effect counter B. EMF part 2".
The project will consist:
Inside:- Stator with 18 coils.
Middle:- Rotor made of steel with slots ( I still working ). The lathe part was done but I need to machine the slots.
Outside :- The magnets array, with ceramic or neodymium.


Check the pictures..
Ariovaldo

Guys,

JLN and TinseKoala have already shown motors that don't manifest generator action (BEMF) - the ORBO and Orbette.

To be strictly correct... only the Orbette 2.0 has actually shown this effect. It is a Core Effect motor, it does not operate by electromagnetic attraction/repulsion.

Applied current to the carefully toroidally-wound coils causes a change in the magnetic permeability of the special core material ("square" loop hysteresis in the B-H curve), saturating it magnetically. 

This change in permeability reduces the attraction of the core to permanent magnets, equally without regard to magnet _or current_ polarity. This allows the non-intuitive Core Effect which drives the motor: the magnets in the rotor are attracted to the toroidal cores when the coil current is _off_ and are less attracted when the current is _on_. Again, equally without regard to either magnet or current polarity. So the Core Effect drives the rotor by allowing full strength, non-powered, attraction as the rotor magnets approach the toroid, and _reducing_ the pull back attraction as the magnets pass "bottom dead center" and begin moving away from the toroid.

This Core Effect allows one carefully to position the toroidal coil-core assembly near a double row rotor so that the fields from the magnets "null" at the position of the core assembly, hence virtually eliminating any generator effect that is normally caused by moving magnets past a coil. The unique thing about the Core Effect is that this does not affect the actual magnetic attraction to the ferrite toroid core! So it is possible to tune the motor so that no normal generator effect occurs, but the rotor is still driven strongly by the Core Effect change in permeability.

Steorn even claimed that the rotor magnets in the approach to the cores actually helped drive the cores to saturation, enabling very small currents to "finish the job" and produce the full Core Effect.

What isn't true is Steorn's claim that this process produced overunity performance.

However, this is a very different thing from "delayed or no Lenz effect" or the production of CEMF by current supplied to the coils. These effects happen whenever coils are supplied with (pulsed) current.
The Orbette toroids still produce an inductive backspike when rapidly switched off -- which happens at a time when the magnets are maximally distant from the core!