@wattsup:
If you removed the flyback from a monitor and judging from the looks of it being still intact, i guess you haven't removed the HV diodes / kenetron ?

[quote author=AbbaRue link=topic=7679.msg303026#msg303026
Take a "calcium hypochlorite" capsule with water every 2 to 3 hours. 

Very Important!  This could save TK's Life.


Thank You my friend for your advice
I will rely this to TK

Effect of ´electron- or ion-cascade´ is known by special arrangement of conductors, like used e.g. at Testatika. Picture EV AEG 12 shows construction in principle.

Sheets of capacitor are winded spiral. One sheet takes negative charge (red), on surface takes positive charge (blue), between both sheets isolating material is installed (here not drawn). Several of such units are arranged one by one, where each inner end of sheet is connected with outer beginning of next corresponding sheet (here marked by thick black lines).

When discharging that capacitor-cascade, more ´electrons´ exit than originally put into system and ´ionisation´ is detected. Both effects however are only side-appearances, process by itself exclusively is based on pressure of Free Ether onto charges resp. overlaying motion ahead of current. Above this, no normal capacitor (-dipoles) nor isolation are necessary. Much more effect will show naked surfaces or wires (here thus only minus-sheets) which are exposed to Free Ether directly.

Ether is moving by light speed (at its local limited areas) and electric current can also move (approximately) by light speed (apparently ahead). Nevertheless, differences of lengths alongside spiral bended surfaces are important. Layer of charge show basic pattern of motions onto which is impressed overlaying motion-ahead (and synchronously also cross to), both by certain speeds.

At inner side of spiral, distances become shorter and space becomes more narrow, i.e. ether there comes into ´stress-situations´. Resulting of is thicker layer of charges at inner parts of surfaces. Free Ether affects stronger pressure into these thicker balancing areas, i.e. also with accelerating effect. Relative to length of conductor thus current will flow (apparently ahead) faster and faster towards inside of spiral. Alongside bended sheet-surfaces, charge layer will ´slip´ ahead increasingly faster. At round wire-surfaces, motions wind around-ahead correspondingly faster.

At picture EV AEG 13 schematic is drawn such an ´acceleration-cascade´, where conductive wire (red) is winded spiral and its negative charge resp. current runs through three of these truncated cones one by one (A, B and C). At the end of that unit, not ´more electrons´ appear, but charge there is impressed by overlaying motion much stronger and faster into direction ahead.

Within such coil-cones for example is piling up accelerated ´bow-wave´ with corresponding inertia into direction-ahead, however also with corresponding ´suction-effect´ into backward direction. Previous mentioned ´pump-effect´ thus is generated by this conception, now however only by direct affecting pressure of Free Ether onto charge-layer.

So it´s important, Free Ether can affect most free onto charge layers, i.e. these coils should be winded loose. Such units could be build by large scale or several of these coil-cones could be installed within small box, like e.g. sketched at this picture at D by view top-down (four coil-cones at different levels are arranged within box of not-conductive material). This current now should be allowed to ´fall into depression´.