Yes a good find, I found one in English I sent the link to Nick as he kept waffling about a self-starter device, ask him to post it to you it showed everything and told you how it works to, I don't have the link now my machine doesn't keep links if i just turn it off and it did just that after i sent it!

Good Day All

Just wanted to report an interesting update which *might* answer some questions that were raised about a year ago here.

I have converted my SSTC (SolidStateTeslaCoil) to run off of solar.  Well, I use an inverter and 12V deep cycle battery for the power supplies.

On my YouTube channel I posted a couple of videos sometime last year:  SSTC Ground Current; https://www.youtube.com/watch?v=RUEBzjiGLPs
and SSTC Ground Current 2;
https://www.youtube.com/watch?v=wysm0Zxpz5k

In these videos I was using the Public Grid as my power supply.............. and a few people rightly asked the question:

Will the light bulb light-up if you run the SSTC from an ISOLATED power supply?

MagPwr at the same time presented a video where he lit-up an LED thru inductive coupling using a small Ferrite toroid.

Tonight I finally got around to running the SSTC from my Solar battery powered ISOLATED inverter.

For who will ask, my entire house runs ONLY on PhotoVoltaics (solarpanels).  I do NOT have a Grid connection at the house.

The inverter in question is COMPLETELY isolated from Ground............. meaning the inverter does *NOT* use a ground connection anywhere in it's circuit.  No ground  loops here

So, I wound up a small HF choke toroid, (the type for common mode chokes, etc.) and placed 5 parallel one watt *straw hat* White LEDs wired in series through a 220ohm resistor and wrapped only 1 turn of 22awg wire around the toroid.

Have attached photos of the test apparatus.

The toroid / LED / resistor combo was placed on the *far* end of the 10awg. GROUND cable (ground cable put through the toroid), which is about 5 meters distance from the SSTC when operating.

The LEDS light up super bright............  whenever the SSTC is discharging the LEDs are on.

I do realize the LED can be made to light up by very little current, and soon I will find a small incandescent AC bulb, like I used in last years videos to try the test again with Solar power supply.

The *Grounding* of the base end of the Tesla Coil forces the 1/2 wave coil into 1/4 wave operation yielding a voltage node & current antinode at the grounded base connection. 

This likewise renders a Voltage antinode & Current node at the *far* end of the the 1/4 wave resonator (usually the end with the aluminum toroid).

Considering that the Voltage antinode is at *ground potential* it should have ZERO volts...........
but this is obviously NOT the case.

The *Ground Cable* is demonstrating *real power* (some part of it must have voltage & current in phase) as it can light-up 100watt incandescent light bulbs.

It is late tonight and I did not take a video.  I will make a video of this with the Toroid placed over the Iron bar used as the ground rod and post it soon.  Also I want to find another Incandescent Light Bulb and redo the Ground Current video with the isolated power supply for the SSTC. Should prove interesting.

take care, peace
lost_bro

 
P.S. Jeg; I will answer your questions in your last post A.S.A.P.

So in other words Ruslans device is built around an active material that only exists in Russian Ferrox TV scan coil and perhaps other ferox they might manufacture or did.

So all the electronics that's been on here wont work with out the number one ingredient ! any one got a supply ?

 or

End of thread !

Hoppy thanks for such great reference.


Acca.


ps I have no question about that, a specific combination of iron and "other minor elements " contribute to the Kapanadze effect ... as to the sound of resonance some effects are in the audio range and some not.. Why is a TV yoke ferrite present in all Kapanadze devices ? There in no question of the yoke video that Wesley has on his channel from 4 years ago.. The ferrite effect is real to me..

   There is no yoke on Tk's bedroom device.  Which started this whole story.
   Some other guys are using ferrite toroids instead,  such as apecore,Ruslan, Stalker,  etz.
   I use yokes from China and Japan. We'll see if they will work to self run my device.

do not look for BTG (not) looking for the wave is said to be so -. the process. interaction of resonant circuits for receiving the waves.

Is this from Igor device ?

@magpwr (only because I know you have simulator experience....)


How does an AV plug work in a simulator?
If a voltage to one side of a capacitor requires a current through the cap and out the other side, how does the current flow?


I tried a few things.... (falstad sim)
but adding other capacitance around the diodes or to a ground to simulate capacitance in the wires does not help?[/size]

hi d3x0r,

I don't recomend using a virtual environment to test out certain circuit like:Av plug,ferrite and etc.

But i did create something similar and simplified 1 wire flash circuit powered by 1x AAA battery few years back as posted in my youtube channel :Sanjev21

Avramenko plug -One wire supply automatic flashing ver 3.0 -Final version
http://www.youtube.com/watch?v=YG5zUKOrboY