I bet those radiant heaters the Amish are selling on tv are better than this unit they've got here.

Hi All!

HHOHHU seem to be more efficient and cheeper.
They answer my question:
"452 watts power draw will heat an area rateed for 40000 btu".
Is not very precised answer, but Sovereign Energy Solutions use
these technik too.

Kolec

I wanted to show some calculations from the figures given for the
   New Pre-built hhohhu Heater.

Manufacturer's cost to end user: $1999.00 USD

Manufacturer's specification: it produces heat at the rate of 130cfm at 125degrees F.
                                        : input is 300Watts electrical continuous.

I am guessing an input air room temperature of 65degrees F.
I am also guessing 130 cfm means continuous forever.

---

This means: 130 cubic feet minute with a delta Temperature of 60 degrees F

---

I have found the following sample calculation on the Web that I am going to adapt:

130cfm at 25 degrees F delta temperature
 is 3510 BTU/Hour
 is 1.02KWatts continuous power electrical

---

Now for the new hhohhu heater:

130 cfm at 60 degrees F delta temperature
 is  9424 BTU/Hour
 is  2.45KWatts continuous power electrical

2450Watts/300Watts =  implies an energy gain of:    =>  Times Eight (8.19)

It would seem like they are getting some modest gain from their HHO unit
and probably some more from their technically mislabeled "heat exchanger".
Which is actually a catalytic regenerator.

---

:S:MaskSCoffman

Here’s a link to their vague plans:

http://www.hhohhu.com/plana.php

Enjoy

Thanks Shane,
but I get a: "username, password logon" request on April 18, and can't get
beyond it to any useful text. They mustn't want people to see their plans. 

:S:MarkSCoffman

Here is something new that I have never seen before.  "Assume" we plug a 10 Amp electric heater in the wall.

1.  The 10 Amps flowing to & from the heater is being WASTED strictly on the heater.

2.  Instead, let's put those 10 Amps to work instead of wasting them.

3.  The 10 Amp heater doesn't care if we put something in series, as long as it gets its 10 Amps.

4.  How about placing a Hydrogen Generator in SERIES with 1 of the Heater Wires.

5.  We adjust the Conductivity of the Hydroxy Gen so it still gives the Heater its 10 Amps.

6.  Now we can use the FREE Hydroxy Gas to heat the house & are still PAYING FOR ONLY 10 Amps!!!

7.  Now we are getting double or triple the Heat from those SAME 10 Amps.

The PRINCIPAL is SIMILAR to Battery Switching to recharge the dead battery with FREE CURRENT from the 2 good batteries.

Comments are welcome.