@marco
Have you had any further success in your new set up that you were working on??? WHat type of torroid are you using a 1" and with how many winds/bfiliar/guage?? I think the good people here would like to replicate.
Hello Stprue
I have had no further sucess using heavy magnets.
The core for the kick coil that i used in the early experiments can be found inside electronic equipment and over cables.
These are ferrite rings (noise filters) that are placed over cables to supress noise, i am sure you have seen some of them somwhere especially in SMPS's.
I just wrapped one coil of wire over the ring and started to pulse it so no bifilar or trifilar configuration.
The experiment has changed alot since the first video was made.
I was always looking for ways to get rid of the mass because the more mass you move, the more energy it takes and also more mass makes it impossible to go faster.
So then it came to me i needed the smallest magnets available and then it struck my mind!
Electrons....
So i have now replaced the moving magnets by a beam of electrons and now there are no more heavy magnets to drive.
It's a fairly basic principle.
I have what i call the spraying wire which consist of a electron spitting wire.
It has a sharp tip and it spews out a fluid like plasma stream.
Offcource the mass of this setup is nothing compared to the heavy ferrite ring magnets i used in the early days and so it can go much faster and with much less power too.
But the generation of high voltage is somewhat tricky.
You see to smoothly modulate extreme voltages is quite difficult compard to a low voltage coil drive like in the early days.
That is why i decided to add some modulation coils too in setup number 3. (i will add a drawing for you so you can see what it looks like.)
With this new setup i can now also report to you that i have witnessed gravitational interaction.
Marco.