@Hoppy, why think the braid is trickery when the green box vid did not use any braid it used a really heavy earth wire wound round a water pipe, and it could be clearly seen only one connection 100%. I have watched it many times and no way was there any other feed to device. Most interesting was the inverter was used in between looping, and then battery removed. I assume doubters think in other demos this start battery is hidden? In fact I think TK just got cleverer and now uses small 9volt for starting by improving circuit.And in doing so could say look no batteries.
Regards
Keith

1. Firstly the neutral wire of the mains is connected to the water tap/water pipe for one ground wire. ( the tap wire )

2. Secondly an active wire from the mains is previously buried in the garden below where the radiator is to be buried
maybe connected to a conductive plate. The radiator wire.

3. When the radiator is watered in  well a low resistance path is created between the buried wire and the radiator with the wire
connected to it.

4. Take both wires to the demonstration bench and connect them with an assistant observing from the flat/house.

5. On a given signal the assistant flips the switch to energize the radiator which powers the lights however is desired.

6. The battery shown could be recharged by the mains while doing it.

The garden video could maybe be faked how i described back in August.

Cheers

These excerpts are from "Steven Mark's Torroidal Power Unit" v2.0/2007
"
I hope things are calmed in your life when you receive this.
I fully understand your feelings of frustration.
To work hard to see nothing of a positive is sometimes shattering to one's
self.
I know very well...
I had a great deal of help and it took us years just to develop a SS control
system that would work!
And this is after we knew how to make generators!!!
...
Speed is energy if you can convert the mass into energy quickly
enough!
Anything no matter how small can store enough energy to convert
into huge amounts of energy.
Even electrons.....................................
Now, electrons can travel only so fast along the surface of the wire
because of magnetic flux.
What if you disable the effects of the flux?
My unit operates on these principles.
Now the electrons float freely without anything holding them back.
Electrons at the sped of light are now a possibility!
How much energy can be converted from a stream of electrons traveling
close to the speed of light?
...
They also have no concept of how important the control
frequencies are in order to make power from the collector.
...
I assumed that anyone working on technology this sophisticated would
have a superior knowledge of electronics and an understanding of PURE
frequency output being a Necessity to control the reactions going
on inside the collector.
...
Sincerely,
SM
"

"Dear Tariel:
1) Provide us with all the necessary parts needed to build the device (assembly kit)
2) Then let us figure out how to connect these parts the right way to make it work"
Would love to hear his reply!

I think Wesley proposed sth very similar to him and even arranged a 7-figure investor.
TK was vacilating too long and did not meet the investor's deadline.
You could probably get more details out of the horse's mouth.

Then hit the copper disk/ring with the spark, not the surrounding coil as suggested by McFreey. Could be that helps.

The idea is not bad at all. Only, the energy of electrons accelerated in the spark is not high enough to invoke the necessary reactions. It may also be difficult to inject the electrons from the spark to where they are needed.

@farmhand, the green box gen only uses one earth, first attempt with radiator not good enough earth- so wire was changed to water pipe. Water pipe was checked first to show no voltage. Then wire connected and twisted tight for good connection. Only one wire goes to gen not two so where is the circuit to fake, then all is lifted up to show only one wire.
Regards
Keith

If the coil was pulsed then, when the coils's circuit opened, the induced voltage exceeded the wire's insulation breakdown point.
Coils "want" to keep the current through its windings constant "at all cost" - even if it means developing 100kV across its windings.

No pulsing, just plain sinewave from directly from the grid. That is why I thought it was rather weird. Not a mild shock but a hefty one.
 
If 100 kV can be produced between turns with pulsing, then why not then just pulse a coil and pick this 100 kv using a coil that is perpendicular to pulsed coil ?

If 100 kV can be produced between turns with pulsing, then why not then just pulse a coil and pick this 100 kv using a coil that is perpendicular to pulsed coil ?

Coils care only about the current or flux, not voltage.  You can pick up voltage with a capacitor but not with a coil.
Also perpendicular coils don't interact with each other.

@farmhand, the green box gen only uses one earth, first attempt with radiator not good enough earth- so wire was changed to water pipe. Water pipe was checked first to show no voltage. Then wire connected and twisted tight for good connection. Only one wire goes to gen not two so where is the circuit to fake, then all is lifted up to show only one wire.
Regards
Keith

Take another look at the green box video 2. The camera man twice pans into the street showing a car parked in the road - why. Look to the left of the car and there is a wire attached to the top of the fence which runs high up across the garden into the trees behind the demo area. This cable then drops to the ground and runs behind the row of people viewing the demo and curves round to the other side of the table passing beneath the array of lamps. Seeing things like this shows how easy it would be to fake this particular demo. I cannot trace it any further but it does run along the ground close to the table. There is far too much going on in this video to rule out fakery.

Hoppy