Hi guys,
             How do we know that bifilar windings were used in the Hubbard coils, in fact, all the coils mentioned earlier?\

I haven't read that anywhere.

Regards

  Nice post IS.  You store up the counteremf.  I think counteremf is supplied by neutrino kinetic energy and is responsible for the zpe effect. 

Remember Ottos ECD CC coils. They were wound starting with a partial bifilar with a continued secondary winding over it. Since bifilar coils can also act as a capacitor, I think his CC could have also acted as an all-in-one resonant circuit since he had both the capacitor and the inductor as being shown by @armagdn03. Having three of these on a mobius loop and have them resonate all three at once on that one mobius loop could have worked to move current through the mobius while consuming only the energy required to keep the CC resonant. Hmmmmm.

perhaps they wernt used in the faction we normally woud use  them maybe they are used in a transformer faction  ie primary and tuned

secondary and what if the secondary is really your resistor and your choke coil when we think tesla this sure seams to be the case with his

steel ball or spear a top some of his coils...  ever see the 6 spear tesla coil?? 


ist

I went back and read every post. I haven't built anything along these lines, but I'd like to inject this into the forum, as the topic has been covered only a little. The excitation method Hubbard used was a HV source sent through an automobile distributor that had possibly a variac that controlled motor speed that spun the distibutor shaft.

If I have a distributor with 8 plugs wires, I could send a pulse train out the top of the distributor instead of the other way around. I could tie the plug wires common to the HV source and have 8 high voltage DC fast transit events per revolution of the shaft. A thousand RPM on the distributor would then mean 8 thousand events.

It appears that he was (guessing some more here) watching for a bulb to light (or a space heater to glow) to indicate he was "in the area" as he adjusted the variac. I'm going to guess also that he didn't vary the HV impulse strength, just the timing.

Each set up he built probably had it's own timing. I imagine that the most important part of the thing is that he probably made sure that his wire lengths on his coils were matched.

@Otto!
Great links!

How great?

I spent 2 minutes there and came to this:

It will be noted that this hexagonal construction of coils and magnets and two "rotating" sub-circuits has absolutely no source of power. Yet, to the mystified Coler and Dr. Schumann, it nevertheless managed to produce, or better, transduce power seemingly... from nowhere.

And so it goes:
The Schumann resonances (SR) are a set of spectrum peaks in the extremely low frequency (ELF) portion of the Earth's electromagnetic field spectrum. Schumann resonances are global electromagnetic resonances, excited by lightning discharges in the cavity formed by the Earth surface and the ionosphere.

There will always be free energy as long as lightning strikes.
And the real joke is 'Lightning never strikes twice'. Now we know it always does somewhere and discharges through the planetary dielectric causing immense waves. Let's surf the EM tidal waves.

That is what the Hubbard does with the distributor. It creates lightning... Stress the dielectric, get a return. Or know there is a stress point some where on the planet and read it elsewhere, Coler.

Is there any information out there that shows the compression factor of the dielectric after lightning strikes? We know the speed is fast because part of the wake of the collapse is a sonic boom. Before that is very, very, very high speed potential. Remember the wake comes from a point and spreads out and slows down. We only experience the later part of that. But copper picks up a larger spectrum higher in that energy dispersion and lower.
Driving down the highway during a rain storm at dusk, lightning struck the tarmac about 15 feet away. From the side I saw a 1 foot wide shaft of whitish blue energy. Macadem blew up and hit my truck. I never heard a thing due to the proximity and the pressure wave was going away beyond me. Fatest damn thing I ever saw.

The TPU looks like a cross between a Magnetic amplifier and the Coler device. The Coler device is similar to Dollard's TEM/LMD setup. Now we know the SM17 produced sparks like a stun gun(uhoh, here we go). The SM17 had 2 fuses on the back. I did that and showed sparks. His unit did not show sparks on the back of the coil. But he could have easily put the first stage inside the black box to hide the first spark gap stage. Stun gun has it, Tesla coil has it, I did it. Coordinate the two rings for BEMF collision in space(between the top and bottom ring) and you have the output stage of a stungun. Just no sparks? I was warned about putting (2) 15 foot diameter rings on a simple stun gun.

--giantkiller. Boom...

@EM

I've always believed those two missing words were 'field flashing'.

Cheers,

BEP