No problem. I ordered about $500 or more worthy of materials, so I guess I will build it and share the failures or may the successes.

Only one thing was very strange about the second "self-running video" where when he connects the second cable to the positive of the battery, where the other one was already there, and he removes both at the same time and shows the machine running in self-mode without the battery.

One can noticed that the second cable IS connected to the negative of the battery too. At 12 volts 7 amp battery it would easily melt that cable for the 3 seconds he was holding it on his hand. I have to revisit that video again, I could be wrong, but It looked like it was a dead short and not heating or burning his hands.

Fausto.

I did read the same somewhere in Russian forums  -  this no shit short circuit made funny for guys, they concluded that battery must to be totally dead up and this short discussion about this wonder machine ended on the spot the same way.
To be fair then I have not seen it myself, dont know what exact video it is 
cheers,
khabe

I was praying this does not happen! The offer he got was not money is Life or Death! The last post was not him that is so clear. My advice to everyone: 1. Fake all your details online 2. Switch off GPS on your phone 3. Browse from any anonymizer site if possible 4. Continue replication

Advice to admin: zero tolerance to sceptics. They could not get people to stop replication so they had to get the source.

My 2cents.
Goodluck. Be safe. We have also heard little from John bedini lately

Hi Stefan.
any chance of a link to that final schematic, the last one I got was posted by Groundloop, maybe it is still the up-to-date one.
Also maybe you could post it on the home page for all to see, without having to trawl through the whole thread.

Just get the version 1.1 of my PDF file here:

http://www.multiupload.com/TQ5UZT4YXU

There it is all in there.

Regards, Stefan.

Are you guys talking about the black wire that seems to be divided into two white wires with a larger white wire going to the red wire on the left and the smaller part of the white wire going to the negative post of the battery?  What you are looking at is a piece of shielded cable.  The white wire going to the left is the insulation around the center conductor which is copper which you can see is twisted with the end of the red wire.  The other smaller white wire is probably not really white but silver and is the shield part of the cable.  I have made hundred of connections that looked just like that.  RomerUK is already gone so why are you guys still trying to beat a dead horse?  You should have realized by now most of the people reading this thread believe this is real and you are not going to change our minds with your silly accusations.

Carroll

Here is the exact on-off switch location.
I just updated these 2 diagrams, that were still wrong in the 1.1 PDF file.

I just see,
that in the
looping_motor_setup2.jpg
the start voltage position from the battery is still wrong.
In the video it was on the other side of the DC2DC converter...
but that is not so important, as the unit starts also itsself
when turning without any battery, RomeroUk said.


And the analog input ampmeter is also still missing,
but this is only a minor detail.
It is directly behind the Dc2DC converter output,
so it will also register the current going through the 20 Watts bulb.

Regards, Stefan.

ROMERO ROMERO ROMERO!!!! BUDDY ARE YOU SERIOUS YOU HAVE PERPETRATED A FRAUD?

People let this be a big lesson if you ever achieve overunity make dam sure you have every detail down to the type of epoxy you used and how much and every measurement!

And if you can afford the time even share a link on where you purchased every part from.

It will save you much headache then you drop this in there lap it will be purchased and built lickity split.

There will be no questions just replication make it with everything purchase ready! So its just a matter of slapping it together if you do not do this it will give people time to stop affording you the short window of belief that you have!

I am a little at fault for the whole deal and I do apologize to all of you out there who have stuff on the way... But I knew the questions would start pouring in so I tried to get them out of the way right away to prove there are no batteries or trickery...

Aside from all of this if he did pop open the DC converter it would likely run cooler and have a slightly better efficiency so why he was so against this is beyond me?

And as far as the cap goes if you visit www.badcaps.net you will find out that even caps were being pirated back in the days people were using cheap caps and putting them inside caps with a good name and the wrong specifications this is how some of the orientals got rid of all there bad capacitor stock.

Would you not want to verify this is not the case with the capacitor you are using?

Finally you just built an overunity device would you not want to go out of your way to prove that it is in fact overunity???

If he was really christian I would say that he is lacking of some of the morals of a christian the lord was very forgiving according to the bible and he sacrificed so much even his life so he could die for the sins of man and yet this guy cannot forgive a simple question or sacrifice ten more minutes to make a video with the capacitor being torn apart after the running of the device I do not understand?

Anyhow he can leave and give up that is his choice just remember when it comes time for judgement and you are waiting at the pearly gates and you did not make just a little more sacrifice to possibly save the billions of people headed for starvation and homelessness around the globe if your name is not on the list you will know why. There is a reason you were given this gift while the millions of others may have missed it... At the end it is all about what you have done to make the world a better more fair and equal place it aint about how many cars you had or whatever you don't take them with you and that is what a true christian believes no matter what!

Finally as far as the guy being rich if we were able to replicate this thing he would have received many more millions in donations then he ever would have gotten from some oil company or the DOE plus he would also go on to live for ever even after he was dead and gone.

Just some things I believe he should really consider if it is real cause if I were him I know it would be on my mind.

Hi folks, As the old saying goes, 'you can't burn the candle at both ends' and expect to be free, money is all illusion, as is much else.
Here is what I have so far, using 5/16" diameter steel bolts, for now, though ferrite cores can be easily be attached to this setup later.
The reed switch is only temporary, to see how the motor function works and I'm waiting for glue to dry on other 5 coils, polyurethane glue takes awhile to dry.
peace love light
tyson