What I don't understand is why any replicators are not using Steven Mark's coil method, he used 300 ohm flat double stranded antenna wire, I revealed his technique but I don't see anybody trying to duplicate it.

I think that if Steven Mark's coil really does work then it should be copied exactly as his until it is fully figured out.

What I don't understand is why any replicators are not using Steven Mark's coil method, he used 300 ohm flat double stranded antenna wire, I revealed his technique but I don't see anybody trying to duplicate it.

I think that if Steven Mark's coil really does work then it should be copied exactly as his until it is fully figured out.

he used 300 ohm flat double stranded antenna wire, I revealed his technique but I don't see anybody trying to duplicate it.

Otto recently said the ECD is not the way but it was a stepping stone to his present works.

Also.......................

Please show me where this is seen, said, referred to, etc.

@ramset

Here is the A of my ftp OU site.
http://purco.qc.ca/ftp/

Thanks for pointing out @Edges (for short lol) post.

I wonder why it was put in the JuleThief thread.

Really interesting idea of the antenna wire, but I do not think it is, simply because that pattern could be caused by the outer taping of the toroid. The width of the tape could be hugging inside a wire turn and give that effect, that is not visible anywhere else around the toroid.

Then you would have to ask yourself, if it is antenna wire on the LTPU, then where is it in the other tpus.

But one thing is very funny that I have just noticed on that photo. It shows the two center toroids, one in the front of the other. Now if those toroids are the exact same size and build, and given the perspective of the photo, the front toroid should be seen as bigger then the back toroid. But take a good look at them. lol

Now look at his second photo of the LTPU ring, I don't think it is made of metal or magnets. It could have an inner channel with wires going around like a tesla coil primary but this also I doubt. For me the use of that ring is totally useless as a structural requirement, but, if the platform on the inside of the LTPU was raised (to hide the starter batteries), as I have shown before, then that outer ring would help keep the illusion from being too visible.

But good work and I am glad some are still looking at the tpus and finding interesting things.

wattsup