Free Energy | searching for free energy and discussing free energy

Congratulations!   YOU DID IT!!     

Hello All,

 I'm in Florida for about a month. I will continue my builds when I get back.

I hope we all can work together to solve these high gasoline and diesel prices, we all need to realize we need to work as a team if we are going to change the future.

Tom

Hi Tommey
Have you worked out where the "free energy" comes from and what provisions are necessary to utilize it?

I realise that this explanation has many supporters but has anybody yet make it work that way?
Do you really think that Clem had the knowladge to apply that sought of science?
I was under the impression that no oil was used by Clem on his journey and that it was only needed to be changed after months of use.
I also believe that the high pressure and temperature only applies at the nozzle inlets. 
Nevertheless I hope it works out for you
Cheers
AB

Hi Tommey,
I engineered it in this way:

I used following concept, it is a very old concept you even could buy in the 70s. There was a plastic rocket which you filled up with a little bit of water and than you pumped it up.
Without the water the rocket did not lift...but with the little bit of water it was shot to the sky.
Same effect using a empty water hose at your house...you open the focet of the empty pipe only a little bit and at the end of the hose the water comes out as a explosion.

Translatet to a wheel with small, round, conic water channels you need allways to inject water-air-water-air.
By turning the wheel water presses the air and the air presses the water out of the jets.
Important is that the channels should be small in diameter, starting about 8mm diameter going to 4mm diameter.

My engine using a timing of two injections at same time, at 12 o´clok and 6 o´clock.
So only in this position the channels are getting water in.
With an adjustable timing I could adjust more or less water injection.
Air is added by special drilled holes at the center of the wheel. holes work as a walve without need to close the holes.
Centrifugal force of the wheel will manage that no oil comes out of the air holes.
My system should run by itself at a  speed of about 1900rpm.
I will take some pictures of the device which had been professional built by a construction company.
My device had some issues as square not conic channels, so it was only one time running super shortly by itself and even did not work by trying to get it running again.
extremly complicated to adjust air, water, RPM, Waterpressure. And important to use oil instead of water. I run it on a nice place...so was not possible to use oil...

You only need to watch the time when it was engineered, it was the rocket time and even at scool they teached the water rocket effect..and you could buy the rockets as children toys.

I am very sure that this simple construction should work, but it will be not a easy job as only a single parameter needs to be wrong.

We should need a hydraulic engineer to prevent mistakes...

my thougts....when you make a combustion before the liquid is entering the channels it could not create the pressure which is neccessary at the jets and it could not selfrunning...