Stiffler has 12 LED's burning at full brightness with a 14 diode ring. What would happen if we stacked 12,000 diode rings in a steamer trunk? Could we get a "Luxor Spotlight" of 144,000 LED's running off a 9 volt battery?

Where is the receiver coil connected ?
Like here:  https://www.youtube.com/watch?v=PqsVQPLXi3E   if i interpret it correctly:  coil - diode - LEDs - diode - coil

It's a 3 second job to build the plug. The plug will act as the test receiver. Everyone thinks it's funny that this is causing you a problem. I built my first one 15 years ago. I was just as confused, and you'll be just as surprised as I was when you discover how simple it is.

You don't need a physical connection to the coil to generate electricity at this point.

schematic;

Ok... i built it like in the pictures. The LED is working when i connect the plug to the open end of the transmitter coil.
But it's also working when i connect it to the generator output directly, without the coil. And it works at any frequency.

It doesn't work as a wireless receiver.

Attach a clip wire to the end of the coil. What kind of diodes are you using? Fast switching Shottky are the kind preferred. Try turning the power up to 20 volts. Watch you don't burn the LED out. Check it if possible periodically if you're making contact.

1N4148

O.K. The diode checks out. You're very close to illuminating your first LED with wireless power from the Quanta. You made tremendous progress so far. Maybe it's time to take a rest and reflect on your achievements.

I'm sorry you went ahead with thick insulated wire. I didn't realize what you were up to in time. It was a mistake to use insulated wire on the coil. Insulation kills the resonance. Magnet wire is essential.

Think about what happened. You lit a bulb through a single wire. Why; The capacitance is seeping out between the wire and the insulation. It can't broadcast through the insulation. Understanding why the LED lit at all will show that your experiment was at least a partial success. That's not electricity! That small amount of power flowed in from the "Infinity of Space". There is a ground to the signal generator, but the ground from the generator is laying on the bench; So how could it be possible that there's electricity flowing through the coil wire? The voltage that lit the LED from the end of the coil wire was not generated by the signal generator, but channeled from the Quanta.

You officially succeeded! Congratulations.

plug and plug schematic;  try and connect the coil to an aluminum plate, and retest the plug.

I'm sorry you went ahead with thick insulated wire. I didn't realize what you were up to in time. It was a mistake to use insulated wire on the coil. Insulation kills the resonance. Magnet wire is essential.

The method i used to measure the resonance (ringing the coil with a square wave) does not only show the SRF, it also shows the Q factor (how fast is the resonant oscillation decaying). I didn't see any significant difference between my magnet wire coils, and the other coils with the thicker insulated wire. However, there is a difference: the gaps between the windings are much tighter with magnet wire, this means that the capacitance between the windings is much higher.

But i have another doubt: the coils in the Lidmotor and DrStiffler videos can not have a SRF of 13.x MHz. That's completely impossible. I started with coils of similar dimensions, and their SRF was FAR below 13 MHz. I think the DrStiffler/Lidmotor coils had their SRF on a subharmonic of 13.xx MHz, maybe 1/2 or even 1/3 of this frequency.