Author Topic: 2Sgen "Cook" resonator (Read 15239 times)

synchro1 · « **Reply #15 on:** October 18, 2019, 11:46:49 PM »

Self looper

Look at the components in this self loop circuit; 321hz d.c pulse square wave, Audio amplifier, spark interrupter and magnets, frequency transformer, capacitor, battery, FWBR:

https://www.youtube.com/watch?v=jwJd6KPmWl0

The 3rd Shumann frequency is 20hz. divided into 321hz equals 16. which is 2, 4, 8, 16. The 4th harmonic of the 3rd order Shumann frequency.
____________________________________
__________________

synchro1 · « **Reply #16 on:** October 20, 2019, 12:01:14 PM »

Finished version

The 2Sgen output coil needs to connect to double tuneing capacitors. The pulsing of the twin capacitors with a second interruption, excites the dielectric field that broadcasts the electric portion of the wave, while the magnetic wave travels through the ground; So the 2Sgen would position under the output coil and a capacitive bell would broadcast the longitudinal wave. This system benefits from a good Earth ground.

The capacitors broadcast the electric wave.

The electric wave is instantaneous. The magnetic wave is superluminal and travels through the ground, C times Pi over 2. Additional resonant receivers would multiply power. One receiver can charge the power capacitor, and the whole system would run itself!

synchro1 · « **Reply #17 on:** October 21, 2019, 12:57:30 PM »

Phi

The double tuner acts as an amplifier when we tune for "Q".

Raising the voltage in the transmitter through an extra coil to the antenna capacitor, raises the voltage on the receiver capacitors in resonance, instantaneously regardless, of distance.

Dr. Dollard states that the total value of the dielectric field is "Phi" and equal to one. He defines this as "Counterspace" because the dielectric field has no location.

We can raise the voltage instantly raising capacitance in the resonant receivers, with no resistance, by tuning the amplifier up in the broadcast transmitter along with them. The inductive coupling would have to be tightened to increase the power.

We need to tune for capacitance. A "Quantum entanglement" results.

A crystal radio can illuminate LED's from Hertzian radio waves. Gotoluc's "Tinsel coil" does just that, and has nothing to do with Tesla's work. Hoodwinked?

synchro1 · « **Reply #18 on:** October 21, 2019, 11:14:58 PM »

Conjugate theory

Dr. Dollard explains the entire Electromagnetic nature of the Universe as an LC tank resonance with a frequency based on the Planck constant harmonic. Two ways to store power, Capacitive electric and Inductive magnetic.

Everything from Spiral Galaxy formation to DNA!

synchro1 · « **Reply #19 on:** November 01, 2019, 07:08:36 PM »

The problem with distributing wireless power to the fire stricken portions of Northern California with a "Tesla Magnifying Transmitter Tower" is that the power would be recoverable by anyone with a receiver anywhere on the Planet.

Grounded in a high potential "Counterspace" scaler wave, infinite power would be available to draw from the "Earth Dynamo" into the resonant receiver coils from anywhere on the Planet.

California governor Gary Newsome would need to battle the money giant energy companies from around the World to help Dr. Dollard build a Wardencliff in Mendocino.

synchro1 · « **Reply #20 on:** November 02, 2019, 10:21:26 AM »

A grounded coil wth an antenna and capacitor in between will build a charge on the positive electrode. A negative charge will match it from the Earth on the negative electrode. This charge is proportional to the area and height of the antenna.

When the positive electrode of the receiver capacitor is charged by the transmission wave, it has the same effect as raising or enlarging the antenna. The positive charge is elevated and is matched by a negative charge that is generated by the Earth's spinning molten iron core.

The rise in voltage at frequency is a scaler or longitudinal wave that has no fixed location. The "Earth Ground" can be anywhere; The actual Ground is in "counter space".

synchro1 · « **Reply #21 on:** November 02, 2019, 03:03:50 PM »

Mars Rover

NASA could transmit power instantly to the Mars Rover with double tuners. Raising the voltage in the transmitter tuner would result in an instantaneous rise in voltage in the receiver tuned to transmitter "Q" on the Planet Mars. The problem is that everyone could receive free power here on our home Plant Earth along with the Mars Rover with properly tuned frequency receivers!

kolbacict · « **Reply #22 on:** November 02, 2019, 04:39:33 PM »

https://www.youtube.com/watch?v=bbpso7zAlvU
Why didn’t I succeed, what am I doing wrong?

synchro1 · « **Reply #23 on:** November 02, 2019, 04:57:34 PM »

Quote from: kolbacict on November 02, 2019, 04:39:33 PM

https://www.youtube.com/watch?v=bbpso7zAlvU
Why didn’t I succeed, what am I doing wrong?

You would need to remove the resistor and add two variable capacitors to tune for sufficient "Q"; Then you could transmit an intercontinental short wave broadcast signal with a sine wave beat frequency or tune a longitudinal wave that would stand still vertically on the scope and transmit power like quantum entanglement when the receiver was at the same resonant frequency.

A rise in voltage would be detectable by a receiver in a hidden Universe beyond the reach of light!

You can communicate Inter-Dimensionally with the "Multi Universes" if you simply remove the resistor!

Placing a cooper "U" between the capacitors would light bulbs with cold electricity like Tesla's "Hairpin Circuit".

You built a cool CB radio.

Thanks for the excellent demonstration video.

kolbacict · « **Reply #24 on:** November 02, 2019, 07:50:53 PM »

Why are you so ... I was hoping there would be something unusual.
It's cruel.

DavidWolff · « **Reply #25 on:** November 02, 2019, 07:56:39 PM »

I did start to smile a bit while reading your post, till you mentioned hairpin circuit

what with variable capacitors in the 1uf yo 50 uf range do they do them?
Still? why not find the inductance of the windings and do it that way? and then attach an SG and scope and find the resonant frequency of each transformer and making them that way?

synchro1 · « **Reply #26 on:** November 02, 2019, 09:45:00 PM »

My point is that the transmission power required to raise the voltage in one Tesla resonant reciever would raise the voltage in all the multiple Tesla recievers in range with no additional input!

The question many people pose is: Would it be possible to generate more power from the receivers then we input by transmission wave? The answer is yes; Because the power is matched by a free ground charge and the total power is a function of overall copper mass and antenna area, not input.

kolbacict · « **Reply #27 on:** November 03, 2019, 08:57:14 AM »

capacitors were selected in resonance with the used winding.
it turned out 60uf.but why is there no effect like on the video?

synchro1 · « **Reply #28 on:** November 03, 2019, 01:36:44 PM »

Quote from: DavidWolff on November 02, 2019, 07:56:39 PM

I did start to smile a bit while reading your post, till you mentioned hairpin circuit what with variable capacitors in the 1uf yo 50 uf range do they do them?
Still? why not find the inductance of the windings and do it that way? and then attach an SG and scope and find the resonant frequency of each transformer and making them that way?

Pico farad trimmer capacitors in parallel with the existing capacitors would help raise the "Q" to broadcast quality.

The double tuner was perhaps the greatest invention of our modern era.

As we all may already know; Inductors store power in magnetism and capacitors in voltage across the storage plates.

When we raise the voltage in the resonant broadcast transmission circuit, the capacitor is the component in the tuned receiver that actually receives the energy, not the coil. The wave is longitudinal, instantaneous and has a scaler value. Dr. Dollard compares this to raising the thermostat in a room full of people; This means that every multiple receiver capacitor increases in voltage along with the primary broadcast tuner.

Adding a second tuned power receiver to a Tesla wireless transmitter grid doubles the COP of the system!

DavidWolff · « **Reply #29 on:** November 04, 2019, 08:59:21 AM »

Yes yes, I get your drift on the vastly spaced goal posts very amusing comparison a sweaty stinking room

the real answer is to get real and make a cap switch box where you can switch in any value.

With this idea, you might need the power to drive this > Adding a second tuned power receiver to a Tesla wireless transmitter grid doubles the COP of the system!
where would it come from? whereas some one else suggested a hairpin circuit would be special.

I cant reiterate more read Moray King shear skolery books while you still can.

News:

User Menu

Author Topic: 2Sgen "Cook" resonator (Read 15239 times)

synchro1

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

kolbacict

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

kolbacict

Re: 2Sgen "Cook" resonator

DavidWolff

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

kolbacict

Re: 2Sgen "Cook" resonator

synchro1

Re: 2Sgen "Cook" resonator

DavidWolff

Re: 2Sgen "Cook" resonator