Free Energy | searching for free energy and discussing free energy

Solid States Devices => solid state devices => Topic started by: Fysikk on March 02, 2019, 12:41:47 PM

Title: ZPE Battery Research III
Post by: Fysikk on March 02, 2019, 12:41:47 PM
Hi

I have solved the energy leakage problem !!

It turned out that the negative energy cannot conduct thourgh
copper wire and then leaks out of battery !!

Solution :

One copper wire (Positive) + One aluminium wire (Negative) !!

Check out enclosed file for details !!

Sincerly - Kai Anders Wold
Title: Re: ZPE Battery Research III
Post by: Fysikk on March 02, 2019, 09:27:03 PM
Update :

It turns out that the ferrite ring was not necessary !!

I recently bought a better multimeter that could measure amps !!

My earlier multimeter could not measure amps….

This setup makes 570 milivolt + 1 amps :

Copper Electrode
Aluminium Electrode
Salt Water

After the salt had dissolved in the water - i measured 1.73 amps.

Turns out that it was the salt water which makes high amperage !!

Sincerly - Kai Anders Wold
Title: Re: ZPE Battery Research III
Post by: F6FLT on March 04, 2019, 09:34:10 PM
Is 1.73 A the short cut current or the current in a load at 570 milivolt voltage?

The photos of the setup are eagerly awaited.
Title: Re: ZPE Battery Research III
Post by: skywatcher on March 05, 2019, 12:08:43 AM
Congratulations !  You reinvented the galvanic cell.   :)

It turns out that the ferrite ring was not necessary !!

Of course it's not necessary. You only need 2 different metals and an electrolyte.
Title: Re: ZPE Battery Research III
Post by: Fysikk on March 05, 2019, 02:04:33 PM
Is 1.73 A the short cut current or the current in a load at 570 milivolt voltage?

The photos of the setup are eagerly awaited.

Hi i measured the amps with a multimeter !!

Update : I read wrong on the multimeter - it was only 5.2 miliamps !!

Petridish + Water + Salt/iodine + Copper coin + Aluminium foil

Here are the pictures enclosed !!

Sincerly - Kai Anders Wold
Title: Re: ZPE Battery Research III
Post by: Fysikk on March 15, 2019, 12:02:20 AM
I finally got a stable voltage when i used a homemade resistor
in series with my free energy battery !!

Paper strip with a layer of graphite (Resistor).

Copper Coin (Positive Electrode)   
Playdoh Clay (Solid Electrolyte)
Aluminium Foil (Negative Electrode)

Voltage does fluctuate between 355 mV and 380 mV !!

The sweet spot seems to be around 360 mV.

Check out the enclosed image for details and voltage !!

Sincerly - Kai Anders Wold
Title: Re: ZPE Battery Research III
Post by: Fysikk on March 15, 2019, 05:10:05 PM
Update :

The paper strip with graphite is not a resistor but works as a capacitor !!

I found video clips about graphite supercapacitors on youtube !!

Sincerly - Kai Anders Wold 8)