Wesley's Kapanadze and other FE discussion forum

[stivep]

stivep. dont u think your picture with coil is wrong?"" [size=0px]secret of Svobodian engine ( motor)3.jpg[/font][/size]""  in this pic it seems simple bifilar winding style.
guy in video from start mentions caduceus winding style .   
he also mentions in   video about solenoid coil style winding  and tells to wind one layer of coil one direction then u make new layer in other direction
and every layer changes direction and as i understood all these layers all are separate wires. after u finish winding these separate layers u must connect them   
so in the end it would look like caduceus coil (paralleled like your bifilar picture)

https://www.youtube.com/watch?v=A_Zd5L3WXCo&t=4s
However question to you  guys
what is the difference between CC  and CCW coil  winded  on the same former and  the same bifilar  winded  with  double  wire ?
 

Wesley

[stivep]

Hi  to everyone.
And what was this device?
part of the device Soviet-made.
His scheme.

https://www.allaboutcircuits.com/textbook/alternating-current/chpt-8/resonant-filters/
https://en.wikipedia.org/wiki/Voltage_divider
Wesley

[gyulasun]

Hi  to everyone.
And what was this device?
part of the device Soviet-made.
His scheme.

It is very likely a tunable low pass filter whose cut-off frequency can be varied by a DC control voltage connected to the series resistor 
input and the common ground rail.  With varying the DC voltage you can change the capacitance of the varicap diodes hence tune the filter. 
(The series resonant circuits help improve attenuation at further frequencies to be attenuated.)
Here you can see a band pass filter, also tunable by varicap diodes: http://www.amateurradioreceivers.net/blueltnbpf.htm   
 
Gyula

[stivep]

sinusoidal signal is delivered to C1 -
After C1 the LC1 shorts to the ground _{(in Notch filter fashion)}  one single frequency that must be eliminated by  filter.
However this LC1  has  its own  bandwidth so it is primary frequency and    some adjacent frequencies that will be cut.
The LC2 acts similar to LC1


 The L1x and the last L.x a different coils.
-L1X   has 2 winds   
-L.x    has 4+ 2 with extended distance   (pitch) between the winds.( note that you have 21 coils  and only 20 diodes)
That last two winds pitch have been manually  adjusted  to resonance.
rule: the wider is the distance between winds the higher is its resonance frequency.
       If frequency of the rest of Lx coils  differs  from frequency of L.x coil than the bandwidth  of band pass  filter is set.
       If frequency of the rest of Lx coils  differs  from frequency of L.x coil   but it overlaps resonance boarder of L.x coil than  we  have nice clean  continuous widening of band pass filter.



 L1x becomes  invisible at frequency  of its own  resonance as if was not there at all.
the same story is with rest of Lx coils

It is band pass filter where only positive impulses are allowed at the output.
The frequency of operation is in 200+MHz
C1 (2 capacitors  in green color) and Lx  coils determines bandwidth of band  pass  filter.

[stivep]

Widening of bandwidth of bandpass filter by overlapping
Wesley

[stivep]

https://youtu.be/yNs2wc8nRJw?t=352
https://youtu.be/_YPVwfnvqw0?t=326

вот почему ваш CE не работает
Ранняя стадия искровых передатчиков 1901-1927 года
работала с довольно хорошим шумом
из-за ширины полосы искрового промежутка от низкой до 1 ГГц и максимальной на 20 кГц. Вам нужен генератор шума, а не наносекундный генератор.
Вот почему импульсный генератор создания искры ( train impulse generator)
от газового котла является лучшим для его и он был использован в презентации Тариэл Капанадзе мне в 2011 году.
Посмотрите на видео здесь

Wesley

[kolbacict]

1000pf green capacitor.
10pf blue capacitor.
diodes D901a
330Ω resistor.
Thank you . did not expect such interest. 

p.s. D 901 is a varicap.
But why is it a varicap and not a diode?
Generally atypical circuitry.
We could not understand what it was.

[stivep]

https://en.wikipedia.org/wiki/Varicap
https://youtu.be/ngvJ0Wv8cFo?t=449
The Lx coils disappear in resonance increasing the voltage of positive half of an sinusoidal signal
As we decrease the voltage the capacitance is increased.
As we increase  the voltage  the capacitance will decrease. 
      But because we have capacitor C1 at the beginning of the filter than we do not have DC Bios Voltage .
     And because we have capacitor C1 at the rear of the filter  we have it insulated from DC Bios  if there is any.
     If there is no voltage at Varicap than its capacitance will be at fixed value.

So since sinusoidal signal is now changed to  only positive halves  that acts as DC  bios in the time intervals between the halves .( if there  is any voltage >0 )
So to understand it please think of it as system working at Lx coil resonance frequency where capacitive reactance of D901 is compensated to steady fixed and quickly adjusted value .
So think of it as not "important change"  because at output the Voltage will be always the same  and will be compensated  to keep frequency of output signal at fixed value.

However before I will be sure what I'm talking about I need to have original specification of original D901.


here I found:
https://eandc.ru/catalog/detail.php?ID=5793
https://eandc.ru/pdf/diod/d901.pdf
https://www.youtube.com/watch?v=icw8terKP-M

Note: I  said the system work at frequency  200MHz  +
The specification  takes as an example 50MHz  but it is not the highest frequency of Varicap.
Honestly I don't know what is the top limit.
I only look at   coils to determine Frequency of the system resonat stage

Wesley

[stivep]

Advice:
- Connect generator with sinusoidal signal to input
- connect oscilloscope or spectrum analyzer) to output
- gradually increase frequency

Note:
diode  works with  Voltage  from 0 to 50V but.
typical generator gives  around 1V max 10V. so that may be not enough.
For these who don't know  what is varicap /varactor
https://www.electronics-notes.com/articles/electronic_components/diode/varactor-varicap-diode.php
Do not confuse it with  Varistor!!!
https://en.wikipedia.org/wiki/Varistor


Wesley

[AlienGrey]

.

[mkjekyll]

The following link describes how by using nanospheres to harvest evanescent waves from viruses in order to see them without the normal Ab limit issues.

The interested researcher should investigate Nikola Tesla's use of spheres and micro spheres in context with evanescent fields

Hail Royal Raymond Rife

https://www.cnet.com/news/nanoscope-makes-live-viruses-visible-for-first-time/

[stivep]

Tariel  Kapanadze device schematic published  at  realstrannik.com
http://realstrannik.com/media/kunena/attachments/344/file_8febeaf.jpg

Wesley

[tysb3]

@ gyvulys666
all these layers are 2 separate coils in 2 wires. layers need to wind alternately by 2 wires by different directions.

[stivep]

Translation  of the text, attached to the picture posted by me  here :
https://overunity.com/17735/wesleys-kapanadze-and-other-fe-discussion-forum/msg534370/#msg534370


Original  text:
в схему используется принцип Исмаеля Ависо
Ничего не надо больше делать. Схема работает без всякой фапч , сама синхронизируется.
Земля не требуется , это увод Капы. Главное запустить ключ. Он должен слегка быть открытым.
Здесь загвоздка в том что ключ находится под переменным напряжением 15 - 20 вольт 50 гц.
Иначе фокус не получится. Всех это смущает даже спецов.
При таком режиме возникают малозатратный способом волны убийцы.
Капа сжёг ведро транзисторов. Вы молодец умеете рисовать , а я чел прошлого
века плохо владею айпадом. Пока все . Желаю удачи.
ключ коротит катушка в пике амплитудой таким образом беззатратно получается мощные
ВВ импульсах с огромная мощность которые усиливает токовую составляющую инвертора



Translation of text  to the schematic  from above

In the diagram principle  of  Исмаеля Ависо ( Ismael Aviso)  is used 
<sub>I found this link    https://www.youtube.com/watch?time_continue=1&v=XyPRt-uxnKs

original link  attached to the text:
http://mazeto.net/index.php/topic,10995.msg103833.html#msg103833</sub>

 
Nothing more to do.
The schematic works without PLL, synchronized itself. The Earth is not required, this is  Kapanadze concept.
The main thing to start a key. (K)
It should be opened slightly.
Here is the difficulty that a key is in that under a variable AC Voltage of  15 - 20 volt 50 гц. Otherwise it will not work. All this confuses even professionals
In this mode, a low-energy consuming killer wave occurs.
Kapanadze burned  plenty of transistors
Well done, you know how to draw, but  I as a  person from last century I have little control of the iPad. For now. Good luck.
The key will short the coil at peak amplitude so that powerful explosive pulses with enormous power are obtained without cost, which are amplified by the current component of the inverter.
End of translation.


Note: "current component" is the current in the inverter
Note :  relation to Ismael Aviso  mentioned  in translated  text, can be seen as similar to Stanley Meyer and his water car.
https://overunity.com/17735/wesleys-kapanadze-and-other-fe-discussion-forum/msg534102/#msg534102



Wesley

[mkjekyll]

Interesting schematic from Ismael.  His shock wave would be the ferroresonance mode of the circuit in which one can derive the FM magnetic from the AM electric.  The input power needs regulation as one is looking for the bifurcation point of the core material, whatever it may be, in the case that it can achieve saturation from the minimal input as it needs to change state

The first part acts as a laser in which the half wave diode pumps the core to saturation at which point it dumps the magnetic pulse EMP as it drops back down to the relaxed state

One must also use some PCF when moving from RF to DC so as not to backfeed  for transformation to occur and to slow the wave down, similar to a moderator or backwards wave oscillator.



https://www.nature.com/articles/s41598-018-20771-w/figures/1

For the few here who understand this, let them elaborate if they wish...