Kapanadze and other FE discussion

[mkjekyll]

Wesley,

Will the directional couplers rated to 1gHz for CATV work for the low SW frequencies and if so which levels of DB loss will serve better for SWR measurements lower or higher?

Perhaps this is a level of heresy, I don't know just looking for affordable ways to tinker.

Thanks,
Mick

[Void]

Wesley, guys, I posted some links to some video demonstrations of some other types of devices
by Kapanadze including some different types of disc generators, and an apparent hydraulic generator from 2015.
Apparently quite different approaches/configurations than Kapanadze's coil generators.
See those video links here:
https://overunity.com/17735/wesleys-kapanadze-and-other-fe-discussion-forum/msg532768/#msg532768

Apparently the video at the first link is one of Kapanadze's very first demos. It would be interesting
to know what Kapanadze had to say in that very early demo, to compare notes.
Do you think there could be a common principle behind all of Kapanadze's quite different types of generators
(coil, discs, hydraulic)? If you think there is a common principle behind them, what do you see that might be in
common between these three different approaches (besides possible tricks ) ? If they all work on different principles,
then how could Kapanadze come up with three completely different approaches like that? If they are all working on the same
or similar principle, then what may be common between those three different types of Kapanadze generators?
A puzzle for you.

[nelsonrochaa]

   Nelson:   Well, no you didn't clarify the part about self running and self feed back. As most all of the shown self runners are based on a feed back circuit, to keep them going.
   In the video below, translated by Wesley, you are showing a device that needs only a one or just a few second pre-charge to start. But, then it is shown running on it's own for much longer than it would normally be expected from the small 9v battery one second change. As your device was stopped after a short while, I would now have to assume that it does not keep running for much longer than what is being shown, less than a minute.  Is this correct?
     https://youtu.be/mz9NRYQJJt0
    You can also PM me, if you'd rather not discuss this openly. I would understand your position.

Hi Nick,

Nick, I am not going to detail the process used in this circuit, because I am currently disputing in court the intellectual property of this same system, which was retained in Germany by the company with which I was working, but what is demonstrated in this video is not an overunity system, the system was not projected to self run even could self run some minutes , with a resistive load.
It is a Resonant system with some interesting characteristics of "amplification"able to show more work in output than it is input in terms of efficiency, But it is all mere assumptions on my side that would have to be checked in the laboratory with independent and competent entities.
This is a unpublished video where you could see the same circuit without be totally assembled, but show how much power a 9v could store and provide output  to a 60w 220v motor with a a 2kg metal disc on the load.
https://photos.app.goo.gl/JEYdPrEdXYX8AMHR6
All the best Nick

[Void]

Hi Nick, my guess is Kapanadze somehow got his hands on a compilation containing a collection
of different inventions for free energy. Maybe some secret document(s) compiled by some department of
the former Soviet military, and somebody passed it on to Kapanadze, or Kapanadze otherwise got his hands on it.
Kapanadze seems to be a very smart guy. With that basic starting information, he was able to replicate several different
types of devices. Either that, or Kapanadze is pretty friendly with some aliens.

That first generator that Kapanadze shows at the first video link I posted seems to possibly be
an electric motor driving a long shaft with several non-balanced fly wheels on it of different types, and
the end of that shaft drives a generator which loops back and powers the electric motor.

This appears to be different than his other disc generators which might only have two discs of two
different types of metal, and which may be some special type of homopolar generators.

Then the hydraulic generator appears to work on a completely different type of setup.
If you add Kapanadze's different coil generators onto that list, and possibly even a car engine that
can run on water, and you get quite a few different types of free energy generators coming from one man. 
All of them are amazing on their own, if legit. Pretty mind boggling coming from one person.
So, either former Soviet secret compendium document of free energy inventions, or Tariel talks to aliens.

[AlienGrey]

   Nelson:   Well, no you didn't clarify the part about self running and self feed back. As most all of the shown self runners are based on a feed back circuit, to keep them going.
   In the video below, translated by Wesley, you are showing a device that needs only a one or just a few second pre-charge to start. But, then it is shown running on it's own for much longer than it would normally be expected from the small 9v battery one second change. As your device was stopped after a short while, I would now have to assume that it does not keep running for much longer than what is being shown, less than a minute.  Is this correct?
     https://youtu.be/mz9NRYQJJt0
    You can also PM me if you'd rather not discuss this openly. I would understand your position.

Interesting video did you notice the black torrid, now that is interesting.

[stivep]

For TheOldScientist:
Dear TheOldScientist​ I'm very  impressed with your work.
However  I have different opinion about DSW. It  is 2019 now  giving us new light  on the subject matter.
https://overunity.com/17735/wesleys-kapanadze-and-other-fe-discussion-forum/msg532845/#msg532845
The two related to surface wave videos are here. :
https://www.youtube.com/watch?v=zE4GjB1cWLQ&t=565s
https://www.youtube.com/watch?v=yNs2wc8nRJw&t=1s
You may also view, not related but giving  a perspective at some of my lab activities at:
https://youtu.be/GdlkeI0bXy4?t=32
https://www.youtube.com/watch?v=KxEqiS5H1DE
https://youtu.be/izzujmKROWI?t=164
https://youtu.be/k2PJVIkyW5Y?t=34
https://youtu.be/CQ3gPFfgDp8

Wesley

[stivep]

Part2.
https://www.youtube.com/watch?v=pqJzn8Y1HFw

Basic explanation  about  transverse and longitudinal wave.
Electromagnetic  wave ( also omnidirectional) do not require medium,
Transverse electromagnetic wave TEM .......... do not require medium,(TEM means directional wave)
Mechanical   longitudinal wave .............................. requires medium ,
Electromagnetic Surface wave is TEM  needs no medium but needs waveguide  or interface. This wave is traveling inside of waveguide or interface from point of origination A to point where load is connected. B
That travel along the earth/air interface takes time                           
                             
 

Wesley

[stivep]

Tom Bearden,

“Some time in or before 2001, Bearden began to identify himself as "Tom Bearden, Ph.D.", and claims to have written a Ph.D. thesis,
he has never made this thesis public or provided affiliation or details.
The Skeptical Inquirer, among others, revealed that Bearden obtained his Ph.D. for "life experience and for life accomplishment" from Trinity College
and University, which the magazine describes as "a British institution with no building, campus, faculty, or president, and run from a post office box
in Sioux Falls, South Dakota".
This institution is not accredited by any recognized accreditation association and is generally regarded as a diploma mill.
It has since changed its name to Bronte International University and its exact location is uncertain.”
You can call him “Doctor”
They are empty meaningless self-appointed titles.
“Bearden founded and directed the Alpha Foundation's Institute for Advanced Study (AIAS) to further propagate his theories.
This group has published papers in established physics journals and in books published by leading publishing houses,
but one analysis lamented these publications because the texts were "full of misconceptions and misunderstandings concerning
the theory of the electromagnetic field" and also states that ‘existence of non-transverse waves in vacuum does not imply
that electromagnetism is not a U (1) gauge theory.’“
“Bearden supports his various claims with a wide range of crank theories, including the proposal that all electrical devices,
from batteries to electromechanical generators, in reality operate on vacuum energy.

These theories offer no concrete testable predictions, none have been published in independent, peer-reviewed physics
literature, and Bearden himself has little formal training in physics.”
He is not a credentialed ‘Renegade’, a man of science – he is just self-proclaimed set of credentials.

Read also here about  Eric Dollard:
https://overunity.com/17735/wesleys-kapanadze-and-other-fe-discussion-forum/msg532845/#msg532845

Wesley
_{Note: Above quote contains  opinion expressed only.
And  just because it is posted by me.
It is in category of  my  personal opinion expressed.
As it was reedited  by me to fit socially  acceptable format.}

[tsl]

Hello there,
@Stivep i'm really interested in your theory about how one could extract energy from the "schuman wave guide" would you care to elaborate a bit more on that? i personally have only some ideas but no real theory or the needed know how to be able to come up with one

[stivep]

Visited:
Ted A.
2 FE guys
1 university
got 1 electron microscope
1683 miles  in 2 days/2 nights
I'm going to bed

Wesley

literature/ source
main video. https://youtu.be/DNxob3yY4LE
picture1  https://youtu.be/DNxob3yY4LE?t=277
picture 5  and  picture 6  https://youtu.be/DNxob3yY4LE?t=471
Electron microscope stack photo . ( I did not take pictures of it yet)

[lancaIV]

Visiting their laboratory https://www.tedmagnetics.com/ and getting their development results demonstrated :
                                                     C. O. P.  : ?   Impressed  ?
https://patents.google.com/patent/US20150364979

https://patents.google.com/patent/US20090096219A1/en

https://patents.google.com/patent/US20070242406A1/en

Sincerely
OCWL

[AlienGrey]

In that case why do it your self ? when you could have PM'd him?

and he has 3 threads with all the same name, I mean! why let anyone post here at all!!

[mkjekyll]

Hi Wesley,

That's far out, what do you intend your first use of the EScope, checking out core materials?

You must have a large home or a very understanding wife as likely there is gear all over you place.

Mick

[mkjekyll]

Hi Ianca,

That't the flux switching design used in old puter mag ram memory, also the magnetic boots Radis.  Joe Flynn is said to have worked very hard getting the bugs out. http://www.flynnresearch.net/technology/PPMT%20Technology.htm

Requires a rectangular BH curve material.  Or take a step further with conditioned magnets and then one has the Sweet device.

Samsung is said to make a motor based on flux switching but very difficult to find, not sure if they are allowed out of Japan.

Mk

[lancaIV]

Active or passive switch devices :

https://books.google.pt/books?id=iwEAAAAAMBAJ&pg=PA102&lpg=PA102&dq=wiegand+coil&source=bl&ots=05KqLezhpG&sig=ACfU3U0SOyaqT2Z6VAQuCZvO8NKvRb5bGw&hl=de&sa=X&ved=0ahUKEwjGvq6hhqHhAhWtyYUKHXyWDu8Q6AEIGzAF#v=onepage&q=wiegand%20coil&f=false
Probably this is the " electromagnetic phenomena" used by him as "coated wire " :
https://contest.techbriefs.com/2016/entries/sustainable-technologies/6390


Flynn brothers research and usefull info https://web.archive.org/web/20040610131607/http://flynnresearch.net/
Flynns company name now : https://www.qmpower.com/

This  is for me the question for getting the right answer and solution  !?

https://www.tedmagnetics.com/energy/wp-content/uploads/2016/05/Results_v4-e1464274784852.jpg
                                           

                                   EMP/signal input and output ( kind?)