Kapanadze and other FE discussion

[Acca]

 Ruslan Kulabuhov free energy flashlight videos and files..

https://yadi.sk/d/Xpw0TXrF3NNsTt


1 Фонарик
https://www.youtube.com/watch?v=Z4qHPQocEQc
 
 2 Фонарик , часть вторая !
https://www.youtube.com/watch?v=zNbIzIjyEMw
 
 3 Фонарик без батареек
https://www.youtube.com/watch?v=o0R2T_JRGrI
 
 4 Заключение !
https://www.youtube.com/watch?v=ekmi_Xqb8l8
   
   
UPDATE 19 Января 2018
https://www.youtube.com/watch?v=_le-AI8jp-E
 
here are the perpetual Ruslan flashlight diagrams files..
 
 Acca…[/font]

[Void]

This is Ruslan posts from the clip below seven months ago ...
...

Thank you Acca. That is really interesting!


P.S.

Wesley, this part is interesting:
Чую что начинаете понимать ! Но ! именно нижняя обмотка и есть резонатор стоячей волны !!! Но это не приходящая обмотка , а Тесла . Всё что на неё подают ...Типа Дали и остальные... Это возможно ! Например 25 ватт Акула в Германии . Точно такое же чудо делал и я для штатов и у Лорда на канале есть этот девайс. Он в Америке и там его запускали сами американцы. Но у меня там получилось снять 40 ватт и даже чуть больше. Но есть минус .... Тесла там при перевозке изнасилована компанией по перевозке (швырянию посылок) В общем не важно .... Капанадзе говорил про то что это всё доступно каждому и патенты весят в нете в свободном скачивании. Там же есть и ротовертр (Динамо-машина) Тоже кстати одна из этой оперы....

Ruslan mentions that Akula could only get an output of around 25 Watts when he tried his setup in Germany,
and we have seen a youtube video posted previously for that.
Then Ruslan seems to be saying that he made a device for some people in the USA, and it also had a similar problem
in that it could only produce about 40 Watts? Ruslan seems to be saying that this device is in America?
He also mentions someone's name 'Lord' something? DragonsLord76? What did Ruslan say?
Wesley, can you improve on this translation? Sounds interesting...

Regarding this video:
TopRuslan 32 - Аппарат с использованием энергии окружающей среды 16вт
(TopRuslan 32 - The device using the energy of the environment 16W)
https://www.youtube.com/watch?v=L8ABhb5wDJ8

Ruslan commented:
Резонатор в этой системе отсутствует.
искра в качестве гашения  лишних  зарядов
Однополярный
There is no resonator in this system.
spark as a suppression(?) of extra charges
Unipolar

Looks like Ruslan has possibly figured out how to make it work in a similar way to Kapanadze. 
Instead of a tesla coil it has a sparkgap which seems to be firing at a fairly low frequency and pulsing,
as would happen when repeatedly charging a cap to a high voltage and discharging through a sparkgap.

In another comment Ruslan mentioned he would not sell his devices any more because he
had to deal with police and court because someone in Lithuania apparently made legal trouble for him.

Ruslan still appears to be actively experimenting with these setups.
I was on the fence with whether Ruslan's demos might be legit or not, but I am starting to think
they just might possibly be legit as well.

[onepower]

He also mentions someone's name 'Lord' something?

Let me guess?... Lord Kelvin. Aka Lord Kelvin's HV water drop electro-dynamic generator which leads full circle back to one Viktor Schauberger, the water wizard from Austria. Nikola Tesla was born in Croatia almost next door to Austria, maybe it was something in the water?.

[AlienGrey]

Let me guess?... Lord Kelvin. Aka Lord Kelvin's HV water drop electro-dynamic generator which leads full circle back to one Viktor Schauberger, the water wizard from Austria. Nikola Tesla was born in Croatia almost next door to Austria, maybe it was something in the water?.

Oh struth a bottle full of water (a capacitor), Schauberger it means mountain man ! Have you got any thing useful for us like how to wind the bobbin ? mein Freund.

[Void]

I did a measurement of the sparkgap firing rate for Ruslan's mini 16W demo setup with the clear top.
It comes out to between 35 Hz to 37 Hz. The small variation may be due at least in part to my measurement error.
The sparkgap firing frequency on this setup is very regular, so it appears to be fired using electronically controlled pulses.
 

[AlienGrey]

I did a measurement of the sparkgap firing rate for Ruslan's mini 16W demo setup with the clear top.
It comes out to between 35 Hz to 37 Hz. The small variation may be due at least in part to my measurement error.
The sparkgap firing frequency on this setup is very regular, so it appears to be fired using electronically controlled pulses.

Ive seen some of Ruslans compact grenate devices before they just wind an inner tube resonant with the rest of
the wingdings and simply pulse it at that frequency (electronically). There is a formula for finding the frequency versus wave length chosen and also res freq of wire length it was in a commercially available book. Smith Kelly.

[Belfior]

I did a measurement of the sparkgap firing rate for Ruslan's mini 16W demo setup with the clear top.
It comes out to between 35 Hz to 37 Hz. The small variation may be due at least in part to my measurement error.
The sparkgap firing frequency on this setup is very regular, so it appears to be fired using electronically controlled pulses.

Hmm could that be half of 60Hz and he is using something to double that freq? Gap firing to a coil at around 30Hz, caps on both ends of the coil and you end up with 60Hz?

[Thaelin]

Better known as Smith Charts. Learn em, use em, they may be difficult at first but when you grasp them, makes calculating values easy. Then tune it.

[Void]

Hmm could that be half of 60Hz and he is using something to double that freq? Gap firing to a coil at around 30Hz, caps on both ends of the coil and you end up with 60Hz?

Hi Belfior. Not sure what the output waveform might look like because he didn't show
any waveforms, and he may not show any more details than that. Ruslan's setup still seems more complicated
than Kapanadze's early demonstrations, so who knows if these Akula/Ruslan type setups might really work at
all the same as Kapanadze's setups. I think we all do have most of the pieces of what makes up these
Akula and Ruslan setups, as Akula and Ruslan did reveal a fair bit. I think they both may have held back on
one or more important details still however, so more experimentation still needed. I could be wrong, but I think
there may possibly be some clues there in all those comments and videos that were made previously.

[Thaelin]

Waited too long to modify so will add separate. Here is a quote from the search:

 
Smith chartThe Smith chart, invented by Phillip H. Smith (1905–1987), is a graphical aid or nomogram designed for electrical and electronics engineers specializing in radio frequency (RF) engineering to assist in solving problems with transmission lines and matching circuits.

The last five words, priceless.

[stivep]

https://youtu.be/qdJ1V_yDv-c

Wesley

[Void]

Hi Hoppy. Kapanadze was not connected to the grid however.
You can not draw any significant power from the grid with just
a single earth ground connection, unless maybe you are directly
under high tension power lines.

Hi Wesley. Thanks for the video.

The Romancorp demo is questionable to me because it seems to be connected directly
to the grid, which opens the door for ground loops and similar. I am not sure what he was using as the
AC source (generator?) connected to one of the transformer winding pairs there. A separate
generator (isolated from ground?) or connected to the mains... Those kind of tests can be
misleading without taking great care to observe and identify what is completely isolated from ground
and what isn't. I have been fooled myself in some cases until I switched to battery power on generators
and measuring equipment to make sure I was fully isolated from ground.

Note:
When two electrolytic capacitors are connected '+' to '+', or '-' to '-', this is a way to
make a non-polarized capacitor from two polarized electrolytic capacitors. Required if
you want to use polarized electrolytic capacitors in an AC circuit. I would be concerned about
possibly causing an electrolytic cap to explode when doing this, but apparently this is an acceptable
way to make a non-polarized cap out of two individual polarized electrolytics.

[Void]

I will .. after I stop. I'm traveling
 You do not  watch my video  carefully look at
Capacitor voltage Transformer
Capacitive Voltage Transformer Reactor
it is on my video in the  description of the schematic  next to
Tesla coil.
and than google it please.

Wesley

Hi Wesley. I think you may be misunderstanding me.
I was just pointing out that connecting '+' to '+' on two
polarized electrolytic capacitors is done to make a non-polarized
capacitor out of two polarized electrolytic capacitors. I was not implying anything
other than that.
Enjoy your travels!

[Belfior]

https://youtu.be/qdJ1V_yDv-c

Wesley

Hah! Even TheOldScientist agrees with me. He is even saying "try to understand what I am saying!"

His input is 7V and some amps for covering copper losses. He is charging a cap with 165V. With that input. So how many Farads you need to run selflooped with 165V?

[Hoppy]

Hi Hoppy. Kapanadze was not connected to the grid however.
You can not draw any significant power from the grid with just
a single earth ground connection, unless maybe you are directly
under high tension power lines.

Agreed but we cannot be sure that there was not a concealled earth connected to grid neutral.