Wesley's Kapanadze and other FE discussion forum

[Belfior]

Lorentz, Steinmetz and Heaviside normalized Maxwell's equation from quaternions to vectors. Now we can do engineering mat, but did we lose one dimension in the process? Is the OU hiding there?

[stivep]

Lorentz, Steinmetz and Heaviside normalized Maxwell's equation from quaternions to vectors. Now we can do engineering mat, but did we lose one dimension in the process? Is the OU hiding there?

The complete set of the equations of James Clerk MAXWELL are known in electrodynamics since  1865.
 These  have  been  defined  for  20  field  variables.  Later  Oliver HEVISIDE  and William GIBBS
have  transformed  this  equations  into  the  today’s  most used  notation  with vectors.
This  has  not  been  happened  without  ‚background  noise,  then  at  that  time  many scientists
– one of them has been MAXWELL himself
– was convinced, that the correct notation for electrodynamics must be possible with quaternions
and not with vectors.
A century later EINSTEIN introduced  Special  Relativity  and  since  then  it  was  common  to  summarize MAX-WELL’s equations with four-vectors.
For these who likes  active brain masturbation: http://www.zpenergy.com/downloads/Orig_maxwell_equations.pdf

Is the OU hiding there?

My friend there is no OU, never was , never will be  any.
We are not hunting for overunity we hunting for coupling into  energy source, or energy conversion process where we can use energy that does not have to be paid for.
Free energy is just this kind of energy , till governments do not start to tax it.

Wesley

[AlienGrey]

Lorentz, Steinmetz and Heaviside normalized Maxwell's equation from quaternions to vectors. Now we can do engineering mat, but did we lose one dimension in the process? Is the OU hiding there?

Some guy controlling publications at Oxford university decided Heaviside's normalized publication could not be published disclosing that part
of his documents we can thank Don Smith for that information !

OU what we are realty referring in my opinion to is basically how a PW power unit works in particular the fly back device the back EMF
or the collection and storage of it. Being able to make it work and build it is the trick.

Over to you on that one. 

Tinsel K that device it's advertised at 65k up think i will try and get a a 9mhz xtal and a tube of cmos decade dividers 

[Belfior]

My friend there is no OU, never was , never will be  any.

Well I guess it depends on how you look at it. If I power my device with 230V 1A and output is 230V 20A then I would call this OU. More coming out than going in. It really does not change anything if I say "this is not OU. This is just tax free energy that I have coupled into"

When I get this working I can advertize it any way you like. I can say it works by "massaging a pink rhino in 4th dimension and it gives more watts out than what I put in"

Energy Conservation Law tells us that all energy has been created already. We could get really philosophical and say that there is no OU or UO, but only devices with different efficiency of coupling to this energy

[gyulasun]

...  think i will try and get a a 9mhz xtal and a tube of cmos decade dividers 

Hi AG,

You may consider these to get a 9 Hz signal:
1)  There is accidentaly just a 9 kHz crystal on sale at ebay ( https://www.ebay.com/itm/263714732731 ) and you divide the 9 kHz oscillator you build from that crystal by 1000 to get 9 Hz. No need for a tube of decade dividers but only 4 pieces... 

2)  There is the NE567 (LM567) tone decoder IC you may know or be aware of. It has a precision RC current controlled oscillator (better than that of say in the NE555) capable of operating from very very low frequencies. 

What I think it would also be practical to run the built-in oscillator at 9 Hz and phase lock it to the 9th harmonic of a 1 Hz reference clock you derive from a normal 32.768 kHz oscillator and divider chain used in crytal controlled watches.

Yes,  the 9th harmonic of a 1 Hz square wave may have a small amplitude at 9 Hz but using say a 2nd order active op amp band pass filter for 9 Hz would help to clean up and amplify  the 9 Hz signal component to feed the phase comparator input of the NE567 and establish phase lock with its internal oscillator, that would be your 9 Hz output signal.

Of course you would need to use good quality RC components for the active filter and for the NE567 oscillator (R1C1).  Here is the data sheet: http://www.experimentalistsanonymous.com/diy/Datasheets/NE567.pdf  and pay attention to the several application hints too.  Texas Instruments still manufacturs this IC as LM567, what is more a CMOS version LMC567  too.   

Good luck. 

Gyula
PS,  Wesley,  sorry for this off-topic...

[stivep]

Hi AG,
  Wesley,  sorry for this off-topic...

I have no problem with off topic.
The only thing that I oppose is malicious attacks-(an attempt to forcefully abuse or take advantage of someone's ability to contribute to the subject.)
It is not important  if that contribution is real or just thought to be real.
The intention is important, the willingness.
We all have our statue of limitations.
Some of us wish to make some money  on their intellectual property  - I do not But  it is OK. I can understand it.
Some of us  wish to have  everything is for free.
Some of us are very technical
Some of us are to emotional and they express their  approval for FE but at the same time they  express their   worries of - how it would impact the world.
And that is OK with me too.

Wesley

 

[apecore]

Guys,


 I don t know its origin..  or its final doc.

[Belfior]

Guys,


 I don t know its origin..  or its final doc.

From Gerry Vassilato's book

http://www.shamanicengineering.org/wp-content/uploads/2014/07/Gerry-Vassilatos-Secrets-of-Cold-War-Technology.pdf
http://borderlandresearch.com/book/secrets-cold-war-tech/chapter-1/7

Tesla doing disruptive discharges and projecting scalar waves (just voltage potential) that would manifest into current in distant metallic plates

[Belfior]

We also found the shocking effect when tapping a stick welder's positive electrode to a large metal plate. Everybody in the room could feel a shock on their face and skin

[apecore]

We also found the shocking effect when tapping a stick welder's positive electrode to a large metal plate. Everybody in the room could feel a shock on their face and skin

Belfior,
Is it possible to repeat the "test" a several times to see if the effect occurs again?
Maybe ypu could also register some parameters... like voltage.....air moisturecontent etc. to see what the important parametersare?

Greetings

[AlienGrey]

Hi AG,

You may consider these to get a 9 Hz signal:
1)  There is accidentaly just a 9 kHz crystal on sale at ebay ( https://www.ebay.com/itm/263714732731 ) and you divide the 9 kHz oscillator you build from that crystal by 1000 to get 9 Hz. No need for a tube of decade dividers but only 4 pieces... 

2)  There is the NE567 (LM567) tone decoder IC you may know or be aware of. It has a precision RC current controlled oscillator (better than that of say in the NE555) capable of operating from very very low frequencies. 

What I think it would also be practical to run the built-in oscillator at 9 Hz and phase lock it to the 9th harmonic of a 1 Hz reference clock you derive from a normal 32.768 kHz oscillator and divider chain used in crytal controlled watches.

Yes,  the 9th harmonic of a 1 Hz square wave may have a small amplitude at 9 Hz but using say a 2nd order active op amp band pass filter for 9 Hz would help to clean up and amplify  the 9 Hz signal component to feed the phase comparator input of the NE567 and establish phase lock with its internal oscillator, that would be your 9 Hz output signal.

Of course you would need to use good quality RC components for the active filter and for the NE567 oscillator (R1C1).  Here is the data sheet: http://www.experimentalistsanonymous.com/diy/Datasheets/NE567.pdf  and pay attention to the several application hints too.  Texas Instruments still manufacturs this IC as LM567, what is more a CMOS version LMC567  too.   

Good luck. 

Gyula
PS,  Wesley,  sorry for this off-topic...

Gyula thanks for the information I already have a a simple circuit to produce 1hz from 32k768 xtal it' sorting out the 9hz from it that will deserve some thought I already have a couple of LCM567.
cheers
Any way might use a cd4046 and a 4017 divide by 9 should give me the 9hz or any freq 1 to 10 or a chip that has  jam inputs not sure yet depends what bits i have.
AG

[gyulasun]

Hi AG,
You may find this paper also useful from this site once you fancy CD4046. 

Gyula

[Acca]

 “Dr. Le Bon’s texts contain secrets – very deep secrets as concerns radioactivity and the various means of releasing the intra-atomic energy of which he is the true discoverer. As has been validated, Dr. Moray often would study these texts of Le Bon in order to further pursue his various directions in the field of materials science and of vibratory dynamics. Presumably, these topics were advanced far beyond what we have been told, although we see very clear indications that Dr. Moray was learning the exact modes of applying techniques which Dr. Le Bon had begun to utilize in his Belgian laboratory.”
 
The Evolution of Matter
 &
 The Evolution of Forces
Two texts by Gustave Le Bon
 Reviewed by Gerry Vassilatos
 
 
https://borderlandsciences.org/journal/vol/46/n02/LeBon_Evolution_of_Forces_Matter_Review.html
 
It’s energy from the nucleus that is Kapanadze secret as the amount of particles from this de-stabilization of Fe in the TV core would be so small that it would require very precise instruments to determine that. As to Free energy it’s in the “atom”.. 
 
Acca..
 
 Wesley thanks for the history, as I also work in Earth sciences..[/font]

[stivep]

http://energyscience.ru/topic73.html
This is link to Tiger  publications . Tiger(Kazakhstan)  is my friend and he was the one who was asked by Stefanov brothers to be an expert during  negotiations.


Long history short:
Stefanov ( Stephanov) brothers  approached me and ask me to come to Hamburg where they  were scheduled to have presentation of their device.
However  they did not have samozapitka - self looping.
But Akula that just started was in his glory of self-looped no battery and no power supply device.


At the show in Hamburg Stefanov brothers   met an Investor.
German Investor   already knows about Akula
Stefanov was presenting  in Hamburg  less advanced technology when compared to Akula (Kazakhstan)
It would be a moment  till German Investor dumps Stepanov...

Stefanov  brothers ( Russians) - have had no choice but  conserve  their fresh deal ,
approach Akula and  become middle ground  mediator  between Akula and German Investor.
Stefanovs would love to  commit robbery  in  Russian Style  but Akula was not stupid.

In order to  be sure that  device is real they asked  Tiger  who was my friend already due to earlier Lithuania Experiment  to be their  technical expert.
At that time Tiger had no relation  to Akula as of yet.
Tiger  was representing Stefanovs and he could not find any problems with Akula's device.
https://www.youtube.com/watch?v=e_kXFGNdANU
https://www.youtube.com/watch?v=-04V_NIrC0k
 on these videos you see:
- Stefanov the blond hair.,
-Akula  the dark hair,
-and little older skinny guy Tiger .

After that show ,message was related to German Investor  and he visited Akula.
That moment was also videotaped.
https://www.youtube.com/watch?v=mG_FsBn2qxk

In result of these events Akula  went to Hamburg in Germany .
Akula device did not work in Hamburg , and he was in need for Tiger to travel to Hamburg.
Akula contacted me few times.

Based on analysis of that event and another  one - Akulas trip to Riga Latvia
I went to conclusions.

Prior to that trip to Latvia I  advised Akula that he is visiting the same Chocolate Company in Riga that is owned by Russians  murderers who wanted to kill me and  Tariel .
Unfortunately Akulas device did not work in Riga.\
Well fortunately , .. Thanks God  that it did not work. they did not need to kill  Akula .

Me and Akula we went to the conclusion that  the device is geodependent . that means that it work in one particular place  but when taken to   another one ,sometime not so far away it must be re-tuned.
Later on I shared this findings with  few other  key  researchers.
It is worth to say that Ruslan is from Riga Latvia .
Note: (Geo-dependency  of Tariel device was discussed by me   so many times here.)


There was notion  that Ruslan (Latvia) sold  one piece of his device to two Russian trolls 
https://youtu.be/_9foRzZEZRo?t=534

That device was examined and photographed by the buyer  and after long tests trolls  accepted it as working.
After that buyer left and at very next day Russian buyer, started to troll all around... with help of hundreds of  Russian bots "yelling to all internet"  that device is not working.
Since Ruslan did not deny this transaction I decided to  get involved.
The buyer was crying that he has no money to support his family now.
I offered that, I'm willing to give him  equivalent  monetary  compensation in amount of 5k.
I also said that  FE device does not have to be send to me
but I need to  have prove of such transaction  with all of details .
From that point we know that asking  price for FE 1kW is  established at this level.



=================
So Ruslan device is also geodependent . Trolls have the device but  they do not know how to tune it.
 It was also  a push from these Trolls   at Ruslan.

Wesley

[Sergh]

It's good sometimes to read old American books.
In the books you can find answers to various questions.
http://www.gutenberg.org/files/1805/1805-h/1805-h.htm

http://www.gutenberg.org/ebooks/author/634