Solid States Devices > solid state devices
Negative Inductance and measure of Magnetic force.
synchro1:
I was asked to start this topic by Bob Smith on Energetic Forum. I fell it's better suited for the Overunity web site where the controversy originated.
Jeg:
Thanks for posting this Synchro and of course thanks to Gotoluk for disclosing his experiment. Is it much to ask for a simple circuit drawing? I mean, connections are not very clear. Does it have a secondary?
Regards
synchro1:
--- Quote from: Jeg on November 19, 2017, 02:35:44 PM ---Thanks for posting this Synchro and of course thanks to Gotoluk for disclosing his experiment. Is it much to ask for a simple circuit drawing? I mean, connections are not very clear. Does it have a secondary?
Regards
--- End quote ---
@Jag,
The point of the schematic is to demonstrate that the "Inductance of the Coil and Core" decreaase in proportion to the magnet spacing. Therefore; The closer the magnets are to the inductor, the lower the Henrys. The difference in inductance or, the "Negative" amount, is in direct proportion to the inductance it replaces with "Magnetic Force"!!
Here's a new video on the gain from the "Bucking" poles of the neutralization pulse:
https://www.youtube.com/watch?v=2hqnEddy7ZE&t=26s
Jeg:
Interesting.. Especially if the associated ratios IN/OUT change their proportional relation by approaching the magnet. Going to test it. Thanks for bringing this in to attention.
ps. not going on to a discussion about saturation and the associated lowering of inductance and increasing of current. I am interested more in braking the proportionality between the values and if this brake exist here. ;)
synchro1:
It would make a difference on how you ran this GAP motor; In attraction or opposition! The neutralization pulse allows a rotor in attraction to pass, while the power coil acts as a pickup coil for the increased output from the re-gaugingt: The rotor increases the output to the "Hybrid Coil" in rest phase.
Here's a short video demonstrating a latching "Reed Switch": Two "Reed Switch's" would be used, one to direct output to storage or looped to source. This kind of motor could run off a capacitor and an interruptor circuit.
https://www.youtube.com/watch?v=qUqdYdArys4
Navigation
[0] Message Index
[#] Next page
Go to full version