Free Energy | searching for free energy and discussing free energy

Solid States Devices => solid state devices => Topic started by: magnetman12003 on July 29, 2014, 10:35:50 PM

Title: MEG ATTEMPT VIDEO
Post by: magnetman12003 on July 29, 2014, 10:35:50 PM
Here is my You Tube link showing my uncompleted Meg transformer .  Doing it in a much different way than most folks think.

Have already powered up the OUTPUT coil without the input coil connected at all. Parts on order to do that.

Works or not I am having fun.

https://www.youtube.com/watch?v=rTMROhascBg

Tom
Title: Re: MEG ATTEMPT VIDEO
Post by: magnetman12003 on August 09, 2014, 08:40:39 PM
Here is my You Tube link showing my uncompleted Meg transformer .  Doing it in a much different way than most folks think.

Have already powered up the OUTPUT coil without the input coil connected at all. Parts on order to do that.

Works or not I am having fun.

https://www.youtube.com/watch?v=rTMROhascBg

Tom

Its completed now and here is the latest video link 
Appears to be working!

https://www.youtube.com/watch?v=BV2E82sJToU
Title: Re: MEG ATTEMPT VIDEO
Post by: conradelektro on August 10, 2014, 03:06:01 PM
Its completed now and here is the latest video link 
Appears to be working!

https://www.youtube.com/watch?v=BV2E82sJToU (https://www.youtube.com/watch?v=BV2E82sJToU)

In order to determine whether there is OU or not, careful input and output measurements have to be done.

What I see in your video:

1) The lamp might not get 1 Watt. I do not know where the Voltage (about 13 Volt) on the Voltmeter is measured (over the "input = function generator" or over the "output = lamp"). And to determine Wattage one also needs to measure the current = Ampere.

2) The function generator can easily put out 2 Watt: 10 Volt rms x 0.2 Ampere (10 / 50 Ohm = 0.2 Ampere) --> 2 Watt

So, one has to measure Voltage (true rms, http://www.vibrationschool.com/mans/Plots/Plots03.htm) and Ampere, then Watt = Volt * Ampere, for input and output in order to determine OU.

Greetings, Conrad