Aligator31 posted a brilliant design idea using Russian 4x12x62mm ferrite flat bars. I have just finished doing the calculations on that design in a 6 page PDF, which I will post soon.
 
 I show how doubling up on the core stack 6 deep instead of 3 deep to double the cross sectional core area, provides a 1500W device costing less than $400 to build. Further placing a second core stack below the PCB (as just one idea) you have a 3000W device for just a few dollars more.
 
 With only 364 turns on primary coils using 16# wire and 24 turns on o/p gets you a 1.5kW mini-QEG. The calculations show where the problem dissipation areas are, it appears a 27:1 over unity factor is a possibility. Primary voltage is only 200V peak on the primary.

Now when a Lenz law reverse response hits the air-core transformer (the only one that actually exists as a transformer in any real sense driven by a resonance excitation), the effect has nowhere to go in context of the air-core - there aren't any corresponding "air coils", so the effect cascades down upon the coils of the metal-core, and voila - it encounters that dead short, and is slammed to zero excess power. All that happens is a largish reflected load current dissipates plenty of heat in the primary wire, so thick wire is good, but beyond that a BIG FAT ZERO POWER due to the zero volts across that dead short. A 10,000W o/p load is balanced by a 0W power budget in the primary, which is just unheard in the electrical profession. I am an electrical engineer, but in all my born days never would I have ever suspected something like this. All there is in the primary is a few watts in the wire due to the size of the reflected load current. Understanding how that is even possible is the key to appreciating how over unity works

Actually I see a new inverter topology (I have already designed an initial prototype), which incorporates an over unity device built tight into its o/p power section, so the the MOSFETs of the H-Bridge are switching at very low power. The QEG belongs at the input of the inverter, but it is also true an over unity device needs to be built into the inverter itself, to dramatically reduce cost, and heat, power complexity of the H-bridge switching elements.

Don't shoot the messenger. I just received this link and I never saw that before.


http://www.wardenclyffe.es/inicio.html


Cheers
Ariovaldo

Yes, I know.....
Thanks

https://www.youtube.com/watch?v=e_kXFGNdANU




[size=0px]http://youtu.be/-04V_NIrC0k[/size]




Wesley

More from Hope.http://hopegirl2012.wordpress.com/2014/05/30/major-breakthrough-in-free-energy-overunity-demonstrated-in-the-qeg/