Solid States Devices > TPU replications

How to make multiple Kicks

<< < (47/47)

Toolofcortex:
Bruce thought he cold protect the sacred knowledge from me and lock your videos?

ROFL...

Should have known better Bruce.

Raycathode:

--- Quote from: Toolofcortex on February 21, 2020, 05:44:05 PM ---Bruce thought he cold protect the sacred knowledge from me and lock your videos?

ROFL...

Should have known better Bruce.

--- End quote ---
Do they have to be kept cold then  ;D  ;D ?

Toolofcortex:

--- Quote from: Raycathode on February 21, 2020, 05:59:39 PM ---Do they have to be kept cold then  ;D  ;D ?

--- End quote ---

No, but when the storm hits, it will be a cold night.

As the order 66 is given. And my army moves.

And the Dark Lord is revealed to you. Shooting lightning bolts, laughing at you.

onepower:
Yes the secret tpu sauce must be kept cold, very cold and stired occasionally to prevent your jimson saddles from wearing prematurely. If they do wear then god help you and that little sucker will start pulling the nails out of your drywall like it's nobody's business. You have been warned. Unless your renovating then of course hot tpu secret sauce is fine.

Raycathode:
A kicking device what is it well as far as i'm concerned its just a ramp charger of a timing capacitor and a tuned dump coil.
here is a basic circuit I have played and experimented with obviously the components with respect to F and T need careful selection.

Note on the far left supply is actual the cap trigger circuit. On the far right is the cap charge circuit, The scope shot would be a saw tooth
wave with a very fast fly back.

Note this circuit is only in the bread board stage and for Educational experimentation purposes only.

Navigation

[0] Message Index

[*] Previous page

Go to full version