Imagine a scenario where we have a power charger accelerator that charges a C, when C is charged it takes T time, C is then fired into a coil L , ...... T and C and L are resanat circuit, wouldn't that create free energy ? Like kicking a football with the wind

Is this what you mean?


When the capacitor discharges across itself to become a parallel L/C circuit, the induced rotating electric field (with the help of negative energy) creates a difference of voltage between adjacent plates, this voltage according the Gauss law causes new electrons to be present in the system.

If we connect a spark-gap between point C and point D, then the negative energy will be drawn into our system with the same speed as positive energy! The symmetry between the magnetic and electric sides in our positive energy reality will open the correct door for the undetectable negative energy reality!
Initially, when the capacitor starts to discharge, the current increases but the induced rotating electric field will tend to keep the voltage at a high value. The capacitor discharge through the spark-gap (which requires a large amount of voltage), the current flow does not start immediately. Initially, the current increases but the spark does not occur. This pushes the voltage up higher (behaviour which is known in parallel L/C circuits), then the current increases to a high value very quickly, while the voltage is drawn down to a level which cannot sustain the spark. When the capacitor is totally discharged the current flow through the spark-gap is at its maximum value. Consequently, the extended Tesla Bi-filar Coil produces a square wave rather than the expected sine-wave which is produced by an ordinary parallel LC circuit. The square wave produced when the spark occurs, contains waves of all frequencies and so, even if the time during the spark is short, there will still be thousands of oscillations in that time. I know that it is not easy to visualise this, but it is what actually happens.
This special genius design solves the most difficult problems in cold electricity, due to it's reversed behaviour compared to hot electricity. Cold electricity prefers to flow along materials which we consider to be insulators while hot electricity prefers to flow along materials which we consider to be conductors.
According Tom Bearden, with negative electricity the capacitor performs in the way that a coil does with hot electricity, and the coil will perform like a hot electricity capacitor.

The question is how are connecting this?

Clarence is still posting on the Energetic forum and others are replicating.

Successfully replicating? If Clarence has a working simple device it should be also simple to replicate it - not taking months or years.

This is to do with reactive power. A modern meter will compensate for it.

How do you know? What is the difference between a meter running backwards because of reactive power and a meter running backwards because of additional generated power pushed into the grid? How do we tell this apart?

Clarence is still posting on the Energetic forum and others are replicating.



This is to do with reactive power. A modern meter will compensate for it.


Here is something to try:  the CFL bulb scam.


Use a watt meter to measure the consumption of a cfl bulb.
You'll find it is DOUBLE the consumption claimed by the manufacturers.
ie an 18-watt cfl will consume 36 watts.
Power factor again......

is this true or a joke ? I know if you have a 4ft tube is 35 watt  and ballast the ballast will wast another 10 watts I wonder if its the same trick. Also the new Smart meter racket, it's put in for free but then your tariff goes from 18 p to 28 p pluss all your appliances are broadcasting microwaves all around your house and transmitting it to a central point !

   Nelson's diagram of one of his drivers:
https://www.youtube.com/watch?v=TjK6OlYO9Aw

He's not going to give us fish for dinner, only suggest we look at his work and learn to fish on our own.

We can do this if we really want it bad enough.

That schematic should build out to look pretty much like the one below when complete.

Then we experiment.  We learn for ourselves what works and what does not.

Hi guyz


Tip.
Working with Radiant Energy will require you need to think backwards
instead of conventional way most of the time when it manifests.  




 

Nickz,

I'm currently fixing my Push Pull Board, the TL944 with the IR2110 driver
stumbled across some problems after placing new components.
It will hopefully be running this week again for further tests
 

 
  I've even been praying backwards, but it didn't help, either.  I wish that I could sleep at night, just thinking about all this.
  So, Geo, when are you going to show us what you got going? Or are we to just continue guessing backwards?

   Here's another diagram to ponder over.  This one I'm not sure which one of Nelson's devices it represents.
   Thanks, to the person that sent it to me.
   
    Sorry, I'll need to resize it, first. Too big...
   One moment.
   Here it is resized:

   

you have to pray to the god of light, as the dark side one will ignore you ! the woman at the white house said you bin praying to the wrong god !

.