Author Topic: Kapanadze Cousin - DALLY FREE ENERGY (Read 11798436 times)

MenofFather · « **Reply #8055 on:** March 08, 2015, 01:07:58 PM »

Quote from: Tomtech29 on March 08, 2015, 12:22:13 PM

Hello friends wanted to say hi to all community participants.
Thanks to search for a new plan -current project comes from one gentleman who shared the blessed time,I decided to make a similar experience Unfortunately, somewhere something done incorrectly.
Please correct me/ participant of the forum called:magpwr used the simulation very helpful I would be grateful (if you wanted to see and test).

You can try simpler version.

MenofFather · « **Reply #8056 on:** March 08, 2015, 01:13:58 PM »

Quote from: Tomtech29 on March 08, 2015, 12:35:59 PM

The problem is the lack of power at the site of the restriction (20uh) to the stabilizer LM7805 The problem is the lack of power at the site of the restriction to the stabilizer LM7805 20uh
thanks for the MC34064 (leg No.2 pin) I suppose damaged control or something what do you think?

Did you have 5 volts after 5 volts voltage regulator?

magpwr · « **Reply #8057 on:** March 08, 2015, 03:48:41 PM »

hi everyone,

I have successfully created a counterpoise using tesla coil such that it is able to light 220volts 5watt bulb which is "connected to bottom of tesla coil and other end of bulb to earth eg:water pipe"
at less than 1/2 brightness using only 12volts battery which was boosted to 17volts.

I have attached this simplified circuit since i noticed there is stability problem with Akula design using 74HC14 with 6 gates.

Instead of TC4452 i am using IXDD614PI which can easily handle input frequency of 2Mhz.My experiment revealed that the TC4451 or TC4452 limitation is around 145khz.

I am using LTC1799 to generate 533khz or signal generator can be used as well.533khz is the resonance of my other tesla coil.

Using 12volts battery boosted to 17volts i able to power tesla coil using the IXDD614PI output connected via 0.33uf Mylar polyester capacitor and other pri end of tesla coil is connected to GND."Good enough for few minutes of testing"

The bottom of tesla coil is connected to Amp meter at 10Amp settings which merely reveal 17mA for lighting 5 watt bulb to earth although i can tune it to give the max current to earth ground at around 80mA but bulb won't get lit.

Question i keep asking myself should i tune it for maximum current as reflected in my Amp meter or should i tune it for maximum brightness at my tesla coil resonance 533khz

Later on i will use PWM generator TL494.Merely need to connect pin 3 from 74HC132 to pin 3 TL494 which do the job of main oscillator for low frequency.
No time to check the max frequency for TL494 yet.

Then at later stage i will need to figure out how to apply interrupter at 1.58Mhz to switch transistor like 2SC5200.

Time have run out for me since it's Sunday night over here.

Tomtech29 · « **Reply #8058 on:** March 08, 2015, 04:01:01 PM »

Quote from: Tomtech29 on March 08, 2015, 12:24:27 PM

exemplary arrangement

I checked this your idea of the problem is that this is a different scheme

ERROR somewhere here: (Doing this or that could work)?
for a purpose have been mixed in the TL494 pins and I can not catch what's going on?

GeoFusion · « **Reply #8059 on:** March 08, 2015, 05:17:18 PM »

Hi guyz,
check out, how Vasmus is showing drawing on how the fields work and the resonator and everything els that is needed to know.
Circuits must be on own experimentations.

https://www.youtube.com/watch?v=h7nw_FC-kgE

Will be uploading some new stuff soon.

Acca · « **Reply #8060 on:** March 09, 2015, 03:01:26 PM »

John.K1 · « **Reply #8061 on:** March 09, 2015, 03:34:08 PM »

Quote from: Acca on March 09, 2015, 03:01:26 PM

GLOBAL WAVE IS RUSSSIAN ! AND IT’S A FORCE THAT WILL CRUSH
THE WEST SANCTIONS AGAINST MOTHER RUSSIA…..
SAUD HOUSE WILL SHAKE !!

Fingers cross. I want to say you have very big support and lots of people of Czech rep. and other western countries disagree with the sanctions and we all know who is behind it and we will remember it.

Void · « **Reply #8062 on:** March 09, 2015, 04:06:45 PM »

Quote from: Acca on March 09, 2015, 03:01:26 PM

GLOBAL WAVE IS RUSSSIAN ! AND IT’S A FORCE THAT WILL CRUSH
THE WEST SANCTIONS AGAINST MOTHER RUSSIA…..
SAUD HOUSE WILL SHAKE !! ...

Quote from: John.K1 on March 09, 2015, 03:34:08 PM

Fingers cross. I want to say you have very big support and lots of people of Czech rep. and other western countries
disagree with the sanctions and we all know who is behind it and we will remember it.

Guys, as you know, this thread is about Kapadnadze/Daly/Akula/Ruslan devices. Could you please
take this spam/nonsense somewhere else? There is no need at all for this sort of thing here...

Crikey...

John.K1 · « **Reply #8063 on:** March 09, 2015, 04:23:33 PM »

Ok, Kapanadze. I just came across interesting thing. As we know the ground plays a very important role here. I have two separate grounds and I just putted a 1.6W speaker across. An I got quite load buzzing from it. This mean 1) My ground is very "polluted" and doesn't serve well for this type of experiments

2) there is high potential between and it will works very well.

Which is tru?

Void · « **Reply #8064 on:** March 09, 2015, 04:37:09 PM »

Quote from: John.K1 on March 09, 2015, 04:23:33 PM

Ok, Kapanadze. I just came across interesting thing. As we know the ground plays a very important role here.
I have two separate grounds and I just putted a 1.6W speaker across. An I got quite load buzzing from it.
This mean
1) My ground is very "polluted" and doesn't serve well for this type of experiments
2) there is high potential between and it will works very well.
Which is tru?

Hi John.K1. Hmm, are your two ground wires going straight to ground rods/plates in the earth, or where are they connected?
The mains electrical ground for a house or building can be full of electrical noise, but if your two ground wires
go to separate ground connections out in your yard then they should be cleaner as far as electrical noise goes.
You can connect a scope probe across the two grounds and see if you see a lot of noise/signals on the grounds.
First try connecting the scope leads one way, then try flipping them around the other way to see if there is any difference.
The problem with this is that the scope probe ground clip may well be grounded to the mains electrical ground as well, which can
greatly skew measurements of your earth grounds.

All the best...

NickZ · « **Reply #8065 on:** March 09, 2015, 05:31:05 PM »

Geo, and All:
Concerning the Vasmus device(s)...
Here (below) is his explanation diagram from his video.
There's also what's looks like a well made schematic, on another video, I believe.

I'm looking forward to Geo's next video, also from MenofFather, or anyone else still
working on the Ruslan/Akula second video device replication.

I'm still trying to get my yoke/grenade crt to oscillate at a much higher frequency, closer to 27khz or so.
Any ideas are welcome.
NickZ

Enjoykin · « **Reply #8066 on:** March 10, 2015, 02:39:03 AM »

Good News from Russia !!

Successful replication of Limansky motor by Lariman AKA Igor Timonin

http://www.youtube.com/watch?v=NALQTa6s4OQ

Contact Igor here:
http://realstrannik.com/forum/razdel-avtorskikh-tem/91-rotor-vertor-ot-lari.html

Video channel
http://www.youtube.com/channel/UCD5qZcX1gZSHLo5MBoMjL7g

Lariman AKA Igor Timonin
https://plus.google.com/117201440788218033018

Enjoykin · « **Reply #8067 on:** March 10, 2015, 03:37:33 AM »

Aleksei Komarov Etheric Lantern

Based on Patent of famous Russian Inventor and Researcher Pavel Nikolaevich Yablockov from 12 October 1877 - Patent № 120684. Patent name "System of Delivery and Amplification of Earth current by atmospheric electricity from independent current cource". Current output at load is last 2 times bigger than current at input. Confirmed by France Academy of Science and leading France researchers of that epoha.

Goal is in special construction of assymetric capacitor (not electrolitic). Inner (smaller) plate of capacitor must be connected to source and outer (bigger) on load. Good variant are many Layden jars or Tesla types assymetric capacitors.

lost_bro · « **Reply #8068 on:** March 10, 2015, 04:12:26 PM »

Quote from: Enjoykin on March 10, 2015, 03:37:33 AM

Aleksei Komarov Etheric Lantern

Based on Patent of famous Russian Inventor and Researcher Pavel Nikolaevich Yablockov from 12 October 1877 - Patent № 120684. Patent name "System of Delivery and Amplification of Earth current by atmospheric electricity from independent current cource". Current output at load is last 2 times bigger than current at input. Confirmed by France Academy of Science and leading France researchers of that epoha.

Goal is in special construction of assymetric capacitor (not electrolitic). Inner (smaller) plate of capacitor must be connected to source and outer (bigger) on load. Good variant are many Layden jars or Tesla types assymetric capacitors.

Good day Enjoykin

Could you translate the print on the schematic that you attached?
I do not read or speak Russian, and I would like to try to understand what is being presented.
Thanks in advance.
take care, peace
lost_bro

Enjoykin · « **Reply #8069 on:** March 10, 2015, 05:54:31 PM »

Quote from: lost_bro on March 10, 2015, 04:12:26 PM

Good day Enjoykin

Could you translate the print on the schematic that you attached?
I do not read or speak Russian, and I would like to try to understand what is being presented.
Thanks in advance.
take care, peace
lost_bro

Good day !!

Learn Russian language lost_bro !!

It's easy. Much easy than make BTG generator !!

http://www.youtube.com/watch?v=fcstF6k5xQQ

http://www.youtube.com/watch?v=jvCS5qB9aP8

News:

User Menu

Author Topic: Kapanadze Cousin - DALLY FREE ENERGY (Read 11798436 times)

MenofFather

Re: Kapanadze Cousin - DALLY FREE ENERGY

MenofFather

Re: Kapanadze Cousin - DALLY FREE ENERGY

magpwr

Re: Kapanadze Cousin - DALLY FREE ENERGY

Tomtech29

Re: Kapanadze Cousin - DALLY FREE ENERGY

GeoFusion

Re: Kapanadze Cousin - DALLY FREE ENERGY

Acca

GLOBAL WAVE RUSSIAN FREE POWER GENERATOR

John.K1

Re: GLOBAL WAVE RUSSIAN FREE POWER GENERATOR

Void

Re: GLOBAL WAVE RUSSIAN FREE POWER GENERATOR

John.K1

Re: Kapanadze Cousin - DALLY FREE ENERGY

Void

Re: Kapanadze Cousin - DALLY FREE ENERGY

NickZ

Re: Kapanadze Cousin - DALLY FREE ENERGY

Enjoykin

Re: Kapanadze Cousin - DALLY FREE ENERGY

Enjoykin

Re: Kapanadze Cousin - DALLY FREE ENERGY

lost_bro

Re: Kapanadze Cousin - DALLY FREE ENERGY

Enjoykin

Re: Kapanadze Cousin - DALLY FREE ENERGY