Storing Cookies (See : http://ec.europa.eu/ipg/basics/legal/cookies/index_en.htm ) help us to bring you our services at overunity.com . If you use this website and our services you declare yourself okay with using cookies .More Infos here:
https://overunity.com/5553/privacy-policy/
If you do not agree with storing cookies, please LEAVE this website now. From the 25th of May 2018, every existing user has to accept the GDPR agreement at first login. If a user is unwilling to accept the GDPR, he should email us and request to erase his account. Many thanks for your understanding

User Menu

Custom Search

Author Topic: Kapanadze Cousin - DALLY FREE ENERGY  (Read 11719837 times)

NickZ

  • Hero Member
  • *****
  • Posts: 5225
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6270 on: October 29, 2014, 06:00:32 PM »
  We would all benefits from knowing where the additional source of power is coming from, on all these self running devices.
  But, as time goes on, it looks more and more (at least to me), that we are tapping ambient energies, from any available surrounding sources. Can be a combination of both positive and negative ambient/ground currents.  This is still all Tesla stuff... which he knew about, and could tap into, and we still can't.
Unless you're Russian. Ha!

NickZ

  • Hero Member
  • *****
  • Posts: 5225
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6271 on: October 29, 2014, 06:47:51 PM »
  Hoppy:
   Yes, both TK and Tesla were able to run some devices with out the earth ground.
Like with the Pierre Arrow car which did not use a long ground connection, to be able run at 90mph. The new expensive Tesla electric cars would really benefit from that, No batteries...
  Dr. Stiffler had also used what he called a "virtual ground", like a short ground wire only about 15 inches long or so, sometimes connected to an aluminum block, or just into the open air.
  So, it may be possible to obtain somewhat similar results without the long umbilical cord,
which would also allow for a more portable, moveable energy source. Such as  for electric cars, motorcycles, etz...
 

starcruiser

  • Hero Member
  • *****
  • Posts: 693
    • Starcruiser's Place
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6272 on: October 29, 2014, 06:56:15 PM »
Remember that Antennas need a ground plane, they are usually the same length to keep the SWR low. So what if the ground plane in this setup is unbalanced? still a 1/4 wave on one side and say a 1/2 wave on the other?

un-balance the dipole to increase the SWR and gain energy extraction???

MenofFather

  • Hero Member
  • *****
  • Posts: 943
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6273 on: October 29, 2014, 07:30:23 PM »
... My question is , what is the principle of this Akula /Ruslan /Kapanadze device?...
I have version.
Need kacher ajust to inductor or multilayer coil resonance. Ground lengh can also be important, but seems Ruslan divice must work with any lengh grounding wire.


John.K1

  • Hero Member
  • *****
  • Posts: 679
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6274 on: October 29, 2014, 08:17:52 PM »
MenofFather.

Ruslan talked about ground cable- its length- as it becomes a part of your coil and will mess up the frequency and that's why there needs to be added some extra wire  to Tesla coil ( in his case more than 5 meters)

MenofFather

  • Hero Member
  • *****
  • Posts: 943
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6275 on: October 29, 2014, 08:21:00 PM »
Pulses seems is on curent transformer secondary.
Here test of one man http://realstrannik.ru/media/kunena/attachments/5741/Izmerenie_1.JPG

Grumage

  • Hero Member
  • *****
  • Posts: 1113
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6276 on: October 29, 2014, 08:45:44 PM »
Dear all.

I have been making the most of the decent weather pursuing other avenues of OU whilst quietly looking in from time to time here.

Perhaps this short video may shed some light on earth ground issues, you decide ??

https://www.youtube.com/watch?v=RDDfkKEa2ls

Keep up with the great work you are doing !!

Best wishes to you all, Cheers Grum.

itsu

  • Hero Member
  • *****
  • Posts: 1845
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6277 on: October 29, 2014, 10:45:37 PM »
Pulses seems is on curent transformer secondary.
Here test of one man http://realstrannik.ru/media/kunena/attachments/5741/Izmerenie_1.JPG

MenofFather, thanks, very nice, i have re-shown this picture below, see screenshot 1.

I tried the same setup but using my current probe instead of the current transformer, but i do not get these current spikes, see screenshot 2.
So my idea is that the used current transformer toroid is getting saturated giving these spike like signals.
I have a nice sine wave current signal with the probe controller set to 5A/div. so there is lots of current running in that circuit.

By the way, i grounded my Kacher return lead, and it caused the HV signal to be reduced a lot, still visible, but much less.


Regards Itsu

John.K1

  • Hero Member
  • *****
  • Posts: 679
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6278 on: October 29, 2014, 11:34:24 PM »
Guys,

Maybe it was here already, but never mind. Just listening Ruslan's Skype conversation and with my poor Russian I catched this information:

The frequency of small induction coil ( TV choke) must not oversize 10th harmonic. In his case 20KHz . 20KHz has to be signal generator. Than you will get sharp edges."

Cheers

magpwr

  • Hero Member
  • *****
  • Posts: 1168
    • Youtube Channel
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6279 on: October 29, 2014, 11:50:40 PM »
MenofFather, thanks, very nice, i have re-shown this picture below, see screenshot 1.

I tried the same setup but using my current probe instead of the current transformer, but i do not get these current spikes, see screenshot 2.
So my idea is that the used current transformer toroid is getting saturated giving these spike like signals.
I have a nice sine wave current signal with the probe controller set to 5A/div. so there is lots of current running in that circuit.

By the way, i grounded my Kacher return lead, and it caused the HV signal to be reduced a lot, still visible, but much less.


Regards Itsu

hi itsu,

This is a long short or unconfirmed theory of mine at the moment as mentioned below-

Maybe the toroid coupled together with diac or sidac may get below 500ns pulse.

I realized tvs diode would produce flat top at the peaks.so this diode is out of thr question.
« Last Edit: October 30, 2014, 03:28:31 AM by magpwr »

a.king21

  • Hero Member
  • *****
  • Posts: 1650
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6280 on: October 30, 2014, 03:01:14 AM »
I asked Kapanadze specifically about the ground issue. (In retrospect I wish I had specified a non-earth device.)
Anyhow, we have what we have;  Kapanadze told me the earth ground  could be replaced by a circuit. When I pressed him further he said it could be replaced by the negative of a car battery. The team in Tbilisi did disconnect the earth ground for a few minutes and the device continued to function.
This is of course pure Tesla tech, as I have read in the past.


My personal view is Tesla's word that the earth acts as a perfect conductor. I have personally transmitted power through the earth with no losses I could measure. My earth rods are ten feet apart.
I am following this thread closely of course.
I am looking into using the Slayer circuit as a ground transmitter and see where it goes.


Magluvin

  • Hero Member
  • *****
  • Posts: 5884
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6281 on: October 30, 2014, 04:03:41 AM »
I asked Kapanadze specifically about the ground issue. (In retrospect I wish I had specified a non-earth device.)
Anyhow, we have what we have;  Kapanadze told me the earth ground  could be replaced by a circuit. When I pressed him further he said it could be replaced by the negative of a car battery. The team in Tbilisi did disconnect the earth ground for a few minutes and the device continued to function.
This is of course pure Tesla tech, as I have read in the past.


My personal view is Tesla's word that the earth acts as a perfect conductor. I have personally transmitted power through the earth with no losses I could measure. My earth rods are ten feet apart.
I am following this thread closely of course.
I am looking into using the Slayer circuit as a ground transmitter and see where it goes.

Its interesting that the neg terminal of a car battery could be a substitute for earth ground.

Not sure what that means for energy transmission from transmitter to receiver, being there is no longer a connection via earth ground between the 2.

So the neg terminal of the battery must be acting a a reservoir of excess electrons that can be used by the circuit without having to force only the electrons that are in the circuit already around in a loop of circuitry alone.  So I wonder. If it is so, are the excess electrons at the neg side of the car battery available to a circuit without a positive connection to the battery by the circuit? Can they be taken from the battery easily and replaced as easily, or even forced to take on more electrons, by a circuit that does such?  Or is there say a spring function where it takes more and more pressure from the circuit to pull more electrons from the neg side of the batt, or packing the neg side with more electrons than the batt started with? 

Possibly we might need high voltage to push and pull enough electrons from the neg terminal of the batt in order for it to matter at all. Like a AV plug, it appears to push electrons into one side of the cap during one phase, and pulling from the other plate of the cap during the other phase. So only one plate of the cap sees any action during one phase and the other plate in the other phase.

I remember when i was about 10yrs old, I had a couple electronics project kits. When making the crystal radio using ground, I had an idea that since the earth ground allowed the ability for ac current to flow in the circuit, i tried just a long piece of copper pipe as a ground connection. The pipe didnt have to be connected to anything other than the radio ground. And I got a signal. Not as great as the earth ground, but it did work and allowed the radio to be portable without being tied to the ground. Of course the isolated pipe didnt have an abundance of extra electrons as the neg terminal of the battery, but it did give and take from the radio circuit in order for it to work.

Now i wonder if that crystal radio would have played better by just grounding it to a neg terminal of a car battery instead of the pipe. Or play near as good as an earth ground in comparison to the pipe alone.

So is there an advantage to a circuit of a particular type to have more electrons in the circuit(or less as the circuit brings in or pushes out electrons at any particular time) than just the number of electrons in the circuit alone? If there is, what is it? ;D

Mags


URFA

  • Jr. Member
  • **
  • Posts: 70
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6282 on: October 30, 2014, 11:12:52 AM »
Hi Enjoykin.
I have some experiments and I think I have achieved some effect. It is OU effect or not I don't know because I haven't oscillascope.
This effect is possible with Kacher.Without Kacher not effect.(have to be antenna).
There are some problems with the operation of the device . I know what the problem. I am working on it. I'm trying to fix problems.
After correcting these problems, I will share with you a new video.

I now Uploading Videos on YouTube. I'll give you a link when it finishes loading.

Regards Ibrahim


John.K1

  • Hero Member
  • *****
  • Posts: 679
Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #6284 on: October 30, 2014, 03:08:16 PM »
Guys,

Maybe it was here already, but never mind. Just listening Ruslan's Skype conversation and with my poor Russian I catched this information:

The frequency of small induction coil ( TV choke) must not oversize 10th harmonic. In his case 20KHz . 20KHz has to be signal generator. Than you will get sharp edges."

Cheers


 Sorry Guys, I was lost in translation. Ruslan said 100th harmonics.  = 20KHz