and this is my experimental device, and my control circuit

careful with images on this forum... if the image is too big, it will make that page disappear and not be able to load.


Please try to stick to 1280 width; yes I appreciate the detail... but... it breaks things (sometimes).

my topic on a bulgarian mazeto forum: http://mazeto.net/index.php?topic=9026.msg61422#msg61422

   Well it sounds like we are getting a bit distracted here.
   First we were talking about Dally, then Akula, then something else, and then something else again.
   If the schematics are wrong, the coil turns don't match what we see in the diagrams,  or what is seen in the videos,  and the different circuits have different configurations, etz... what we have is a mess to work with.
    Akula does not use a coaxial cable in his device, and still obtains a higher output than anyone else, except for TK, possibly.
  Anyways, which way do you want to go???  In all directions?
  Maybe Hoppy is right, and there may not be a fair wind blowing, yet.

   This brings me back to.... which direction do you want to take, now.

   I came here to this thread a couple of years ago or so, because I was not able to replicate the original TK device as discussed in the TK thread. Mainly because no one could point out just how it really works, or provide us with a proper schematic, or working principals. And also because some of the guys that were there then were into discussing the non solid state TK device, at that time, which did not interest me at all. It was then suggested that I start a new thread. But, as this Daly thread was available and not being use then, I restarted it, to talk more about my interests in the non moving solid state free energy devices, such as the Akula device. The Daly replications had come to a dead end, with no positive results to be had by the few who tried to have a go at it. They know who they are, although I was not one of them, as the talk was that it must be fake, as no one could replicate it with positive results.
  There has since been much discussion about the Akula devices, on this thread, as well as  some other similar induction heater type circuits, which the first Akula device was originally derived from. As it is not just a "kacher" circuit, at all. Although it now incorporates the HV  duty cycle controlled Exciter or Kacher type circuit, along with the magnetic induction circuit, working together and heterodyning into a new frequency. Which appears to be the actual cause by which these self running devices may all be functioning by. Or not?

  Now this Daly thread has taken a new twist, with some hope for those interested in it's possible replication, due to Ruslan's self running device(s).

  Anyways, I just thought that it would be a good idea to try to focus on one thing at a time, and possibly try to obtain some working results. As we seam to be combining ideas, coils, and configurations from different circuits, that may not work as they were originally designed to.
Wishful thinking, perhaps...

   

 

  I'm not sure I understand what "alternatives" you are talking about, which I should consider. As I have not seen any devices made by you or suggested by you, nor have I heard of any other alternatives, either. Other than your mentioning that the Akula device is "just a kacher".
If that is what you think, fine. But, Here (below) is where the original idea of the Brovin Kacher comes from, which was a high voltage but low amp circuit, unlike Akulas much more complicated high amp output type of circuit.
   https://www.youtube.com/watch?v=xMiNnHzFsRQ

  If you are not in agreement with what I'm suggesting in my previous post, that's ok, as I'm not here to argue. or prove a point to anyone.
  If you are suggesting that the original akula device, was not developed from his previous tests and experiments base on the induction heater type circuit, I suggest that you might want to check Akula's videos previous to his first self running device. If they are still available. There he mentions and shows how he developed his self running device from the induction heater based circuit (high amp circuit), and recommends us to do the same in order to understand how it works. I'm not making this up, as you seam to think.
Other than that, I'm not sure I understand your point, especially in reference to my inflexibility.

 
 
                                          NickZ
 

  I'm not sure I understand what "alternatives" you are talking about, which I should consider. As I have not seen any devices made by you or suggested by you, nor have I heard of any other alternatives, either. Other than your mentioning that the Akula device is "just a kacher".
If that is what you think, fine. But, Here (below) is where the original idea of the Brovin Kacher comes from, which was a high voltage but low amp circuit, unlike Akulas much more complicated high amp output type of circuit.
   https://www.youtube.com/watch?v=xMiNnHzFsRQ
 

I didn't say 'just a kacher'.


what I did say http://www.overunity.com/12736/kapanadze-cousin-dally-free-energy/msg407419/#msg407419
https://www.youtube.com/watch?v=IpmxooGBxfw
https://www.youtube.com/watch?v=kDLgX6vMrmM
https://www.youtube.com/user/3zdayz/videos   ... hmm I'd say at 1 year; but there's bad resolution on times there... take your pick on things I've done.
I'm not arguing, I'm just noting that like Observer, you're not very observant.


I wasn't aware I needed to present a resume before being read.


Edit:

Akula ruslan WIP

https://plus.google.com/106503144436194360259/posts/RkqzUwBDPBd 

Oops duplicate can't delete.

kapanadze pattern

oo

which actually goes back to Stivep1's videos and his caduceus with a foil across 2 of the winding cross points.... each wire crosses points in the caduceus coils....