Guys is anyone know what is this 1/3 on Russian's drawing? If for example I make a 37.5m bifi which correspond to 8Mhz. 1/3 means to fire it from katcher with 1/3= 2.6Mhz?

RuslanCircuit Edited-Ver1 circuit is also wrong.
Ruslan circuit in video is corect.

Here Ruslan schematic.

@ Jeg

m 37,5 / 2 = m 18,75

m 18,75 x 4 = m 75

m 75 = 4 MHz (4 wave of 1/2 bifilar coil)

4 MHz / 3 = 1,33 MHz (katcher frequency)

 

Corry, is it possible to say some things more? F.e. why to divide my cable meters by two and then to multiply it by four? What is the theory behind this?
Thanks

Good job menof!
Two diodes in parallel like this, is for capacity reasons and not for current sharing.

Ruslan diagram free energy device.

 http://www.realstrannik.ru/forum/39-kapanadze/134930-ustanovka-ruslana-kulabuxova.html?start=1782
 Acca..

hi MenofFather,

This circuit attached is worst than the edited file i have done.It is incomplete.If it is incomplete how do you say it is the right circuit.

Where is the synchronization connection from the TL494 generator to circuit to provide signal for 2SC5200.

It's just a blocking diode which can be added to the edited circuit diagram if circuit pass the test to go into the experiment stage.

I will find time to implement the edited circuit i have done in virtual environment to observe if the 74HC14 and 7HC00 circuit is able to produce a 3 phase signal as shown in bottom left of the circuit diagram.
In the meantime all the circuit got no credibility.Ruslan obviously don't want anyone to replicate successfully.

What Akula and Ruslan have done good recently is to explain roughly how the device is working.

hi everyone,

I have tested the RuslanCircuit in the virtual environment with the frequency generator by the TL494/Signal generator at around 27khz as signal A.

I am sticking with the 74HC14 and 74HC00 to generate a 3-phase signal or NanoSecond Generator  as shown at the bottom left of the circuit diagram.Depending which one you choose to follow.

I have attached 2 mp4 video of circuit in virtual one using 1kohms pot instead of the 22kohms which is located at the 74HC00  just to show the difference."You decide if this is a 3 phase generator or nanosecond generator"

I have use best available component  for this video circuit diagram.

The 22kohms pot for 74HC14 control the position of the signal B and C ( One is inverted)
The 22ohms pot for 74HC00 control the duty cycle of the signal B and C to as low as nanosecond

This nanosecond generator  is functioning as per my expection ."Thanks to Ruslan"

Please refer to my most recent edited ver 2.0 posting for the full circuit diagram which i have uploaded couple of hours ago.

At this point i unable to spot any errors in the edited circuit.

I will proceed building the buffer stage,using mosfet in virtual in order to test if there is any more possible flaws or intentionally created problems.

-----------------------------
I don't know what is wrong with all the delivery related to Don Smith pending items seems to be long delay maybe due to Year end season.Another weekend nearly burned.
 

"Where is the synchronization connection from the TL494 generator to circuit to provide signal for 2SC5200."
I bealive, that Ruslan divice not have synchronisation.