Free Energy | searching for free energy and discussing free energy

  Hi Geo:  Welcome back. How goes it? Long time  no hear...  NickZ

Hi Nick,

Yes, busy as always with many things that are important.
I'm just here to give hints that will help.
To understand the system is to focus on the Collapsing field part and using a HV swing right when that happens.
this is what gives it the multiplication method. resonances are used to keep in tune for the system to work and the amount that
you want to receive corresponding to the LC configs. Sync is needed as well otherwise it wont work.
then you have to see when kacher needs to be fired on the correct moment when Mosfet of pushpull is off.
The simple kacher has to be turned off completely by a switch, ( MOSFET) for a brief pulse when the collapse of field is
happening on the grenade. You can add an extra FET that will control the simple kacher negative terminal on or off in fast.
tricky part is that, to sync that specific part.
As what Ruslan said long back or Akula, the Tesla coil/ Kacher is what is doing all the massive output work after.
Make sure you only tap from out put after diode bridge. not befor! otherwise resonance is broken.
Bemf is what this output is, I have seen to much but had to say it.

Important EDITED **
** Nick, I reflected on my old videos where in 2016 was a year I almost had it but it was unstable
Yet it performed as Ruslan did but was limited power yet it did not effect the input at all when changing output
load. In those days I had no idea precisely what was going on but was doing my best to understand, but now I do.
The BEMF was present that day at the output , this is why it did not effect the input.
If there were another tesla coil circuit that could handle higher voltages input such as 60VDC would have made this output greater that day without increasing the input.
this is the video from 2016
The output is not affected by touching the antenna that also shows that the operation is different as I am stating.
https://www.youtube.com/watch?v=1weV296sjHU&t=
Now I know what to do , It has taken me 4 years to figure it out since that day.

No look again at Nelsons circuit he kindly published he is using that !

Want to try again ?

It does not matter of his circuit now, yet he had some success but we are working on the Akula/Ruslan/Dniester Device here.
Focus on that.
I'm simply helping giving hints and my findings over the period of times.

Cheers



 

Geo! i'm not disputing you have something working BUT!

this was Wesleys Lithuwanian experiment I don't have one or Ruslans device

but this device worked.

Even Delomorto talkes about it on his wersleys thread
It makes sence Ruslans does not!

Hi Dave,

Yes I am aware of this device and have spoken to T-1000 about it many times.
The way this is making energy is completely different from the Akula/Ruslan Devices.

STAAR Yoke device is doing Ferrite Transmutation energy output. this leads to nasty Radiation from the extra material
they had inside the composite of the Ferrite material. those two frequencies Exited it and release it and within certain
resonance. Not sure if it was mixed of Barium inside the Ferrite.

**On thing Ruslan did not talk about nor Akula is how this energy comes about to existance.
that is where they are bastards for a long time... my time invested to see and experiment what it is all about
came to an realisation. 
By my findings it is Bemf harvesting and havign resonance all over to keep the balance.
The collapsing field energy and having a brief HV HF pulse right after is what accelerated the output.
This is the type of output when loading it, will not have effect on input. Simple as that.

Ruslan's lastest videos back then for sure did show he using other ways how to
 but it is the same outcome and method he is using but difference devices to get it.

Again, STAAR device is comepletely different, Unless you are trying to to nuclear resonance on copper
which is not the thing here right now.

Ruslan did not infact never say what is happening at output but at the video I just posted of my experiment in 2016
RUSLAN did msg me and told me I am close to figuring things out but I had still no clue back then.
Right now, I have.

Hi GeoFusion

Nice to hear from you   ... I am enthousiast  to learn more from you.
On what frequency does your Grenade resonate.
Are the first 2 layers wound one way and the second 4 layers the other way ?

Anyway cool video`s on your channel.

I heard you talk about the modulation coil   .. sounds like  you call that bifilar coil  or  do i misinterpret what you say i do`nt understand what you said there

Utopia Now     I am Happy

   Geo. So,  can you show us wbat you can do now, with your device?

Hi Nick,
Soon, I'm making the bench setup in a much simple way now so when to add and remove is easier and
then to set it back how it was but without instability.

Take a look.
This is one of my recordings 4 years ago
https://www.youtube.com/watch?v=IdMVSiX2V7k

This clearly shows me now that I had something back then and I didn't even realize it up till now...
input is not affected when loading 300W low lumins or not loading anthing , input amps stay the same.
The Back Emf is what is filling up the cap, secret is not the diagram nor special frequencies,
I didn't even wrry on modulation...
Ofcourse for better performance you tune the telsa to the grenade but mines was not 100% tuned to it yet it gave result.
This is all about how you tune the coils and pulses of the tesla coil and when to interrupt when a field is in a certain moment.
Although 4years back it was by luck most of the time also having it right in the spot but not 100%.

***I'll make some sense in this for a moment how i view this device inner workings.
     We need to think and see we are standing near a Pool of water and you are standing at one of the sides of it.
     Now you trow a small rock in front of you in the pool which then creates ripple waves that travel..
     that will travel till the very other side of the pool
     and will reflect against the very end of the other side of the pool and come back
     and on the way the waves are growing larger when it reaches back to your side....
     That coming back ripple is the example just  B.E.M.F. ( a response ) and What if you could accelerate it?
     Imagine now in the when the ripples are coming back and your friend that is on the otherside is trowing a rock but fast
     right behind the ripples/waves and creates a nasty bigger waves that will come back, This is where you induce pulse.
     That is the work of the Tesla coil brief Pulses on the correct moment when tuned.
     So now to bring it on the device, When the Field is generated by pushpull via yoke over the 3T coil serie resonance
     when Current is Highest is where voltage is low then the pulse of Tesla Should be fired to give the amplification effect
     and having the cap at the grenade end to harvest it and in resonance at the same time. it's right when a field collapses.
 
This is what I see and what I have experienced and what I lacked of explanation of the guyz that have it.

Hi GeoFusion

Nice to hear from you   ... I am enthousiast  to learn more from you.
On what frequency does your Grenade resonate.
Are the first 2 layers wound one way and the second 4 layers the other way ?

Anyway cool video`s on your channel.

I heard you talk about the modulation coil   .. sounds like  you call that bifilar coil  or  do i misinterpret what you say i do`nt understand what you said there

Utopia Now     I am Happy

Hi Utopia,

No, I was not busy at all with modulation settings.. and I do not promote that.
Frequency of granade and tesla coils vary for everyone so if you use mines it wont make sense. have to use Scope.
What does make sense is to tune the system when you know you generate a field over the grenade
and when it collapses you have the HV pulse briefly at that moment to Spike up the Bemf that is coming back.

Well I’m not too convinced by any of it. none of it adds up to what Sergey, Enjoykin and Adrian were showing or saying
I get the idea a good part of the tread it's all about muddying the waters, even the grenade isn't wound correctly to get zero inductance.

So what’s your track on the inductive winding what do you think that does ? Come on lets hear the jokes

And then there is the katcher what do you suppose is the truth about that ?

Come on lets rip this original idea of some ones fag packet apart and let see if we can get somewhere.

Thing is if you think the device works as is then there is no hope.

Dave

Hi Dave,

I know what you are saying, Some of these guys have schematics made or did also experiment on it, but maybe also
had no idea what is happening. this is why some of them only show what they think it is without good experimentation.
Some like Adrian Dniester had success with the device and figured it out. but also did not share because he is bought by
companies out there, same goes for Ruslan and others who have it or maybe had...

The kacher, the reason why it is there is to give a short pulse on the right moments of a collapsing field.
It could be any type of HV transformer at work as long as it does the very short pulses it has to do when it's time.
 
Hmmmmm....
It's all to know and see if it is possible but without proper test on the bench there will be no progress.
Do some Uncharted water experiments as how I did
and there we can see what is real and what not, many schematics I have
concluded as BS but not all and some of these schematics are not full given truth.

This Device works, It is just that ppl don't understand it yet.

Without HV Pulse the Device is Useless. it has to be a interrupted one.

ppl are not used to work with some of these energies in this way....

Hi Geo. BEMF (Back EMF, AKA Counter EMF ) is not the same thing as Inductive kickback spikes.
I have explained that several times already in this thread over the years. I believe you are referring to
inductive kickback (AKA flyback spikes).


If someone really has something, they should be able to demonstrate it in an clear and reasonable manner.
All else is just talk.

All the best...

Hi Void,

Alright, hmmmm then it must be that then.
I was not 100% sure if it was BEMF directly but the inductive kickback sounds more tobe it if so.
But the point to all of this is for all to understand what is causing this device to function.

Soon enough I'll post a demo

Cheers.

Hi all. Well what’s bugging me is Sergey made a test single board similar to Geo’s device with the mains filter
but he tunes the katcher driver with a tuned inductor and series tuning cap to produce a very narrow bandwidth
it's 1/3 down in frequency from his yoke. That’s not in the mhz range.

in his later circuits he tunes the grenade and then adds an inductor coil driven by the yoke
I have heard a good few refer to this coil as the 50hz modulator.

Any more yokes on that one because i can think about 5 or 6 reasons why that a no goer on that one.


Dave

   Nelson:   It's good to see you at OUR. You are always welcome, here, there, or anywhere.   We seem to be in a desperate situation now, with very little to nothing to work on, that works toward having FE.   NickZ

Hmm sounds like a good idea that

Nick where is Nelson on OUR ?
a search does no show anything