Hey folks, I'm new here but I'm very interested in free energy devices.
I'm from Eindhoven, it's a city in the east of Holland and also the original base of Philips (Electronics), also known as Aristona, Erres, MagnaVox, etc.

To my dissapointment there is a lot of fake stuf on the internet.
Today I found a video that attracted my attention for the full length of it.
It was shot in one take and looks promising but also very simple. Too simple to be true but also to simple to be fake... Or?

http://www.youtube.com/watch?v=yoCBORXzOqU

It claims to be a "free energy device", one person in the comments is claiming he reproduced it successfully.

I tried it today but I don't seem to get it to work, as a lot of people who tried (see comments).
I have the parts connected, got a neodymium magnet from a harddrive but I don't measure anything.

Could this really work? Or is it another hoax? Have I wasted my free saturday?

Is this the right sub-forum for this question?

Hello . Welcome .

wow . that video sure will throw you for a loop . i will go on a limb and say fake . there is no way this can happen this way . In order for current flow you need something inducing a moving magnetic feild and a harddrive magnet near a coil isn't it . you can also prove it yourself easy .If it was that easy it would have showed up thru 1000's of experiments with coils and magnets.


Gadget

Another wasted saturday? 

Solid state facepalm. He should have at least included a bit of UFO hull material in the circuit. Inserted properly into the coils, it will boost your COP by at least infinity, if not more. If he is all out of ufo hull material, I have some that I'm not using.... I'll sell it cheap. (I've found something that works much better.)

AS far as fake goes Still no one has shown why its a fake . two soldered clips shorted to a coil with an antenna shows almost 6 volts . Hard drive magnets are brittle so i dont see a hollow one with a button cell . and if there is a button cell then how can it feed thru a short . also inductance is out because the volts he reads with his meter is the same dc volts anywhere he moves. only thing left is CG . BUt all the other 16 videos are legit by that youtube poster .
Lots of people comment on such things and never give an exact explanation for comments and it should be that is you respond to someones post who wants to learn then you need to explain it , If it's fake then how . if its not then how . We don't learn anything with unexplained comments that are rude .
A new Person on this forum  deserves respect and since i have came back i am seeing a lot more crap on this board than i did several years ago  .
It's no wonder this community has members that don't come back .
if some are not so smart . some used to be and have lost some brain activity and memory . They don't need useless comments that make them leave . I will take up for them if they are sincere in their endeavors if no one else will .No matter how smart other think they are .

Gadget

Hi,

I don't think it is fake but there is a transmitter somewhere around which induces voltage on the coil.

Hi . and Welcome . That was my first response to this.  BUT the DC value shown is the same throwout the property .I am an veteran licensed  Amateur radio operator now since 83 and i know about how transmitters induce . High tension power lines or some form of induction (AC) will not produce dc voltage (a steady dc voltage) so that theory don't make sense . . If the dc voltage he is showing on his meter is the exact same everywhere then the question is what device will induce a steady  DC voltage and Current wireless?I have never see one. Only ac .realize that it would have to be several feet away . And hidden buttoncell inside of a hard drive magnet don't either . They are brittle and a button cell won't produce almost 6 volts . unless they have com up with a microdot cell that fits in the end of an alligator clip and produces 3 volts(one on each clip inside the jaws of the tips of the alligator clips i just don't know . I have never seen a microdot battery that will fit in an alligator clip . leaves only cg but his other videos are repeatable.
I got to thinking on this and DrStiffler has supposedly made an led light with three tuned coils with no power at all . (he claims even if he is the wireless sec man) Now its not much volts as i have some red leds that will light on a very low voltage . less than 2 volts. So  explanations are in order.

Really strange, I agree... I wonder if it only works at this specific place or not. I find interesting that he says, it didn't work with otherwise shaped magnets. I'll dig through the video comments to look if he has...
Just guessing, maybe he accessed the "Schumann frequence"... (don't know if this makes sense or not :p)

People....please.

If what you are seeing appears to violate known principles, then you probably...with a high degree of probability... are misinterpreting what you are seeing.

You could be misinterpreting for several reasons, among them deliberate deception or illusion on the part of the person who is showing you what you are seeing.

If you will look at the other videos from this same person, you will find another video showing a motor driving another motor, the first one being powered by the generator effect of the second motor being driven by the first motor. There are also some random coils and things in that device too.

http://www.youtube.com/watch?v=f0fwjY6_-1M

The presenter has explained and illustrated that that device was made very simply: by taking apart one of the motors and putting in some button cell batteries where that motor's armature and magnets used to be. A small stub shaft to complete the illusion and you are ready to go.

Now... bearing that fact in mind. please look again at the video being discussed presently, and tell me if your interpretations of what you are seeing are still the same.

What is more likely.... a concealed battery _in the motor housing_  or that a coil and magnet as shown could power a motor?

Now, I've shown real wireless power transmission making a DC output that drives a motor, that in itself is not too difficult to do .... but I have to use a couple of capacitors and a fast diode in the receiver in order to make the AC power it receives in its loop of wire into the DC that the motor wants. The simple coil or two of wire, and the magnet, just won't do it alone.

@Tito
he measures voltage without the motor, even if there were batteries installed in the motor.
So maybe he faked it , but not the way you described.