It looks like it will take mechanical work to get the magnets rotated from step 4 back to step 1.

Note: The top assembly is stationary except for the rotor that can operate turning clockwise or counter clockwise. The lower assembly moves up and down like a piston. 1 shows the lower assembly being pulled to the upper assembly by the power of three magnets. 2 shows lower assembly flush with upper assembly. 3 shows rotor has rotated to the vertical position. This puts the lower assembly and upper in a neutral or even a repulsion mode. 4 shows the lower assembly moved to it's lowest point. 5 shows the rotor turning to the horizonal position and work is needed to remove it from the lower assembly but most of that work is recovered when the magnet is attracted to the upper assembly. 6 shows the lower assembly being pulled with the power of all three magnets. This is the start of repeating the cycle. The pull of the three magnets would be extremely strong as you can imagine.  Also a .005" air gap is between the pole of each magnet and the plate surface so our Pseudo Solid principle will work with no drag on the magnet due to friction.
Thanks,
Butch LaFonte 

See attached

Hey Butch,


This is amazing work! However, I do see a sticky point in step 5 when the magnet tries to exit the moving block. 
I may be wrong.  If I am, please enlighten me.


Best regards,
Cai Run

Yes it will cog but then it will be pulled to the upper fixture to recover most of it. Also if the two magnets each have 100 units each of positive work available during the pull up phase on the piston assembly, then if the magnet does 100 units of negative work in step five then there is a 100 unit positive work available for useful work. Not mention the positive work done when the piston is repeled from the upper assembly.
Thanks for the comment,
Butch

How can it produce EMF?  What is the operation principle?

Our rotary version can be connected to a conventional AC generator. The basic operation is described above. It works on a principle our group (LaFonte Research) developed. We named it "The Pseudo Solid Principle"
Butch LaFonte